HP m7087c, m7188d, m7177d manual Adding Memory, Removing a Memory Module, Installing a Memory Module

Adding Memory

The motherboard contains sockets for DDR DIMMs (double data rate dual in-line memory modules). The exact number of sockets depends on which model you have.

To determine which type and speed of memory module your PC uses, and for specific memory module information and specifications, go to the Web site listed in your Warranty and Support Guide and click the Support link.

WARNING: Using the wrong type of memory module could damage the system.

Removing a Memory Module

1Complete the procedures to prepare the PC and remove the side panel. See “Opening and Closing the PC” on page 1.

2Remove the front panel. See “Removing the Front Panel” on page 3.

3Remove the hard disk drive. See “Removing a Hard Disk Drive” on page 6.

4Gently lay the PC on its side.

5Locate the memory sockets on the motherboard.

CAUTION: When handling a memory module, be careful not to touch any of the contacts. Doing so may damage the module.

6Move any cabling out of the way, if necessary.

WARNING: Do not pull the memory module out of the socket. Use the retaining clips to eject the module.

7Push down the two retaining clips on the ends of the socket until the memory module pops out of the socket.

8Hold the memory module by its edges only, as you lift it away from the socket. Store it in its antistatic packaging.

Installing a Memory Module

Upgrade the memory in your PC with memory of the same type and speed as the memory originally installed in your PC.

CAUTION: When handling a memory module, be careful not to touch any of the contacts. Doing so may damage the module.

1Open both latches of the memory module socket. See “Removing a Memory Module” on page 9.

•If you are replacing a memory module, put the new memory module in the same memory slot from which the old memory was removed.

Or

•If you are adding a memory module, install the new module into the socket nearest the preinstalled module, and install additional modules in the next available sockets.

Upgrading and Servicing Guide 9