Panasonic SC-HT60 specifications Setting descriptions Changing the settings, Other settings

Other settings

MENU	TUNE
SETUP	ENTER
RETURN

MENU	TUNE	INPUT SELECTOR	VOLUME
SETUP		ENTER
RETURN

MUSIC PORT

Setting descriptions Changing the settings

Other settings

AINPUT MODE (Input mode)

This unit automatically detects whether input is digital or analog, but you can fix the input mode.

AUTO: The unit automatically detects whether input is digital or analog.

ANALOG: Select to make the unit accept analog input.

DIG: Select to make the unit accept digital input.

PCMFIX1: Select to input to PCM.

BDRCOMP (Dynamic range compression)

Change this setting to listen to software recorded with Dolby Digital at low volume (such as late at night) and maintain audio clarity. It reduces the peak level in loud scenes without affecting the sound field.

OFF:

The software is played with the original dynamic range (factory setting).

STANDARD:

The level recommended by the producer of the software for household viewing.

MAX:

The maximum allowable compression (recommended for night viewing).

CATTENUATOR (A/D Attenuator)

Turn the A/D attenuator on if "OVERFLOW" lights frequently when using 2-channel analog input.

DDTS-PCM

If you are playing a DTS CD that contains both DTS and PCM, but it isn't playing properly, then select "YES".

If this causes noise to occur, return the setting to "NO". (This setting is effective for each digital source.)

1.Press and hold [―SETUP] to enter the setup menu.

2.Press [TUNE - or +] to select the item you want to change ➡ [ENTER].

3.Change the settings.

AINPUT MODE

1.Press [TUNE - or +] to select "TV" or "DVR" ➡ [ENTER].

2.Press [TUNE - or +] to change the setting. The display changes as follows:

AUTO ↔ ANALOG ↔ DIG ↔ PCMFIX

BDRCOMP

Press [TUNE - or +] to select "OFF", "STANDARD" or "MAX".

CATTENUATOR

Press [TUNE - or +] to select "OFF" or "ON".

DDTS-PCM

Press [TUNE - or +] to select "NO" or "YES".

4.Press [RETURN] repeatedly until "EXIT" appears

➡[ENTER].

1In rare cases, the unit may have trouble recognizing PCM signals and this may cause the beginnings of tracks to be cut off. Select “PCMFIX” if this occurs.

•With DTS, the signals may not be recognized at all. Engage the DTS FIX mode if this occurs.

To engage the DTS FIX mode:

Press and hold [-MENU] and [ENTER] at the same time. "DTS" lights.

To cancel the DTS FIX mode:

Press and hold [-MENU] and [ENTER] at the same time.

The mode cancels when input mode is set to AUTO or when the unit is turned off.

RQTV0110

Note

When a FIX mode is on, the unit cannot process other signals. This may cause noise to be output. If this occurs, select an input 21 mode other than PCMFIX, or cancel the DTS FIX mode.