HP SR1320CF (PJ747AV), SR1300CF (PJ745AV) TV Antenna Connectors Protection, Laser Product Label

Page 22

Should the unit ever require maintenance, contact an authorized service location.

WARNING: Use of controls, adjustments, or performance procedures other than those specified in the Upgrading and Servicing Guide may result in hazardous radiation exposure. To prevent direct exposure to laser beam, do not try to open the enclosure of the CD or DVD drives.

Laser Product Label

The following label or equivalent is located on the surface of laser products:

This label indicates that the product

1

Antenna Grounding

7

6

5

4

3

2

is classified as a

CLASS 1 LASER PRODUCT. This label appears on a laser device installed in your product.

TV Antenna Connectors Protection

External Television Antenna Grounding

If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is electrically grounded so as to provide some protection against voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper electrical grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna-discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.

Lightning Protection

For added protection of any product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug the product from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the product from lightning and power line surges.

Antenna Grounding

Reference

Grounding Component

1Electric Service Equipment

2

Power Service Grounding Electrode System

(NEC Art 250, Part H)

 

3Ground Clamps

4Grounding Conductors (NEC Section 810-21)

5Antenna Discharge Unit (NEC Section 810-20)

6Ground Clamp

7Antenna Lead in Wire

Power Lines

An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits.

WARNING: When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them could be fatal.

22

Image 22
Contents Warranty Support Guide Contact Numbers Software SupportDisplay Monitor TroubleshootingHard Disk Drive Internet Access Keyboard and MouseRecovering From Software Problems PowerCreating Recovery CDs/DVDs Using Recovery CD-DVD Creator System Restore Using the Recovery Tools CDApplication Recovery Starting System Recovery If the PC Is Not Responding System RecoveryStarting System Recovery If the PC Is Responding System Recovery Using Recovery DiscsStarting System Recovery Using Recovery Discs To Run System Recovery Program Using Recovery DiscsWarranty and License Information General Terms Hardware Limited WarrantyLegal Language And, if Necessary Get RepairExclusive Remedy ExclusionsLimitation of Liability Limited Warranty Period Types of Warranty ServiceOptions and Software Limited Warranties Service UpgradesTechSupport/Document.jsp?objectID=lpg50101 Software Technical Support Contacting HPEnd-User License Agreement Transfer Page Manufacturer’s Address Conforms to the following Product Specifications SafetyManufacturer’s Name Declares, that the products ProductEnergy Star Compliance Operating SpecificationsRegulatory and Safety Information Australia Telecom StatementLithium Battery Caution Laser Safety Statement Additional Safety InformationAC Power Safety Warning Class 1 LED ProductTV Antenna Connectors Protection Laser Product LabelPage Printed
Related manuals
Manual 1 pages 31.75 Kb Manual 50 pages 41.56 Kb Manual 102 pages 14.61 Kb Manual 14 pages 2.04 Kb