HP vp19, w2007, w2207, WF1907 manual Wall-Mounting the Monitor Mounting Fixture not Supplied

Setting Up the Monitor

Wall-Mounting the Monitor (Mounting Fixture not Supplied)

Before you mount the monitor on a wall, a swing arm, or other mounting fixture, you must remove the monitor base and the pedestal. You will need a Phillips screwdriver. Read the following warning and caution statements before beginning the procedure.

ÅWARNING: To reduce the risk of personal injury or of damage to the equipment, check that the wall-mounting fixture is adequately installed and secured before attaching the monitor. Refer to the instructions supplied with the wall-mounting fixture and check that it is capable of supporting the monitor.

Preparing the double-hinged monitor for wall-mounting

ÅWARNING: Do not place the double-hinged monitor face down with the shipping strap intact. The hinge can spring up and cause serious damage.

1.Disconnect the power cable and any other cables from the monitor.

2.Carefully place the monitor face down on a flat, soft surface. This might entail elongating the hinge and tilting the monitor back to ensure the monitor is flat.

3.With your fingertips, snap off the VESA cover from the back of the monitor.

4.Remove all four screws from the VESA plate.

5.Save the removed items (cover, screws, and base) for future use.

6.Follow the instructions included with the mounting fixture to ensure that the monitor is safely attached.

The four-threaded mounting holes that are on the back of the panel are compliant with the VESA standard for mounting flat-panel monitors. The15-inch monitor uses the 75 mm spacing standard, while the other models use the 100 mm spacing standard.

Use the four holes to attach a swing arm or other mounting fixture.

4–4 User’s Guide