HP P1130 P4819A manual If OUT of Scan Range appears on the screen

Page 31

HP 21” Color Monitor User’s Guide

Troubleshooting

The Remedies

One or more of the following messages may appear on the screen.

If ACTIVATE USING PC appears on the screen, try pressing any key on the computer, and confirm that your computer’s graphic board is completely seated in the correct bus slot.

If CHECK INPUT SELECTOR appears on the screen, try changing the input signal.

If CHECK SIGNAL CABLE appears on the screen, check that the monitor is correctly connected to the computer.

If OUT OF SCAN RANGE appears on the screen

This message shows the currently selected connector (INPUT 1 or INPUT 2). If the monitor recognizes the frequencies of the current input signal, the horizontal and vertical frequencies are also displayed.

This indicates that the input signal is not supported by the monitor’s specifications.

If you are replacing an old monitor with this monitor, reconnect the old monitor. Then adjust the computer’s graphics card so that the horizontal frequency is between 30 - 130 kHz, and the vertical frequency is between 48 - 170 Hz.

30 English

Image 31

Contents Hp 21-inch color Monitor P4819a Inch Color Monitor HP 21 Color Monitor User’s Guide Important Safety Instructions Minimizing Energy Consumption Minimizing Eye StrainWhat Your New Monitor Offers Where to Place the Monitor Setting Up Your MonitorConnecting the Cables Windows How To Install The DriversWindows XP Windows 95 or Windows # Adjustment Button Using Your MonitorPower Switch Adjustment Button +Brightness and Scroll Up Button Input SwitchContrast and Scroll Down Button To display the Menu Using the On-Screen MenuTo select the menu you want to adjust To adjust the menuSelecting the On-Screen Menu Language To reset to EnglishTo select a language of your choice Displaying the Current Input Signal Selecting the Input SignalNavigating the menu OSD and changes the menu’s Customizing Your Monitor Adjusting the brightness and contrastAutomatically sizing and centering the picture Auto Adjusting the picture SIZE/CENTERAdjusting the size of the picture SIZE/CENTER Adjusting the centering of the picture SIZE/CENTERSelect To Adjusting the shape of the picture GeometrySelectTo Adjusting the convergence ConvergenceSelect Adjusting the quality of the picture ScreenExample of moire Selecting the color mode Adjusting the color of the picture ColorPreset mode Expert mode Variable modeRestoring the color from the Easy or sRGB menus SRGB modeMode green power indicator on for at least 30 minutes. If Changing the menu position Additional settings OptionTo cancel the control lock Degaussing the screenResetting all of the adjustment data for all input signals Resetting the adjustmentsSupported Video Modes Resolution Refresh Rate/HzFactory Optimized Modes On-screen messages TroubleshootingIf thin lines appear on your screen damper wires If no Input Signal appears on the screenIf OUT of Scan Range appears on the screen Picture is not centered No picture and LED is offNo picture and LED is on Colors are not pure370 MHz Technical SpecificationsEnvironmental Information Care and CleaningGeneral Hardware WarrantyWarranty repair or replacement Model Service ProvidedLimitation of Warranty Proof of Purchase and Warranty PeriodLimitation of Liability and Remedies Part II Year 2001 Warranty Declaration of Conformity Regulatory InformationRay Radiation Notice Hinweis für Deutschland Geräuschemission TCO CFCs freons