HP x2401 B6R49AS#ABA manual Installing the Vesa Adapter Plate onto the Monitor

Page 15

Installing the VESA Adapter Plate onto the Monitor

NOTE: This apparatus is intended to be supported by a UL or CSA Listed wall-mount bracket.

1.Remove the stand from the monitor panel. Refer to Removing the Stand from the Monitor on page 7.

2.Install the VESA adapter plate that shipped with the monitor.

a.With the monitor face down on the table, slide the VESA adapter plate from the lower edge of the monitor toward the bracket hinge until the VESA adapter plate is in position over the bracket hinge.

Figure 2-8Positioning the VESA adapter plate

VESA Adapter Plate

9

Image 15

Contents HP L2401x and x2401 LED Backlit Monitors First Edition September Document Part Number About This Guide Iv About This Guide Table of contents Page HP LED Backlit Monitors Product FeaturesExtending the Monitor Stand Setting Up the Monitor1Side connectors Side connectorsConnecting the Cables Monitor front panel controls Front Panel ControlsAdjusting the Tilt Vesa Adapter PlateWhat You Need Removing the Stand from the Monitor Safety InformationRemove the four screws from the monitor stand 8Positioning the Vesa adapter plate Vesa Adapter Plate Installing the Vesa Adapter Plate onto the MonitorRemoving the Vesa Adapter Plate Page Replacing the Stand 13Attaching the stand hinge cover Setting Up the MonitorLocating the Rating Label Turning on the MonitorProduct Support Finding More InformationTechnical Specifications Table A-1L2401x/x2401 SpecificationsL2401x/x2401 Models Recognizing Preset Display Resolutions Table A-2Factory Preset ModesL2401x/x2401 Model Energy-saver Feature