HP x2401 B6R49AS#ABA manual Setting Up the Monitor, Extending the Monitor Stand

Page 8

2 Setting Up the Monitor

To set up the monitor, ensure that the power is turned off to the monitor, computer system, and other attached devices, and then follow the instructions below.

Extending the Monitor Stand

1.Lift the monitor from its box and place it face down on a flat surface.

2.Grasp the stand and pull upward until fully extended.

CAUTION: Do not touch the surface of the panel. Pressure on the panel may cause permanent non-uniformity of color or disorientation of the liquid crystals.

Figure 2-1Extending the monitor stand

3.Place the monitor in an upright position on a flat surface so that the feet are touching the surface. Press down firmly on the top center area of the monitor to ensure that the monitor is stable.

2	Chapter 2 Setting Up the Monitor

Image 8

Contents HP L2401x and x2401 LED Backlit Monitors First Edition September Document Part Number About This Guide Iv About This Guide Table of contents Page Product Features HP LED Backlit MonitorsSetting Up the Monitor Extending the Monitor StandSide connectors 1Side connectorsConnecting the Cables Front Panel Controls Monitor front panel controlsWhat You Need Adjusting the TiltVesa Adapter Plate Safety Information Removing the Stand from the MonitorRemove the four screws from the monitor stand Installing the Vesa Adapter Plate onto the Monitor 8Positioning the Vesa adapter plate Vesa Adapter PlateRemoving the Vesa Adapter Plate Page 13Attaching the stand hinge cover Setting Up the Monitor Replacing the StandTurning on the Monitor Locating the Rating LabelFinding More Information Product SupportL2401x/x2401 Models Technical SpecificationsTable A-1L2401x/x2401 Specifications L2401x/x2401 Model Recognizing Preset Display ResolutionsTable A-2Factory Preset Modes Energy-saver Feature