HP vs19, f1905, f1705, vs17, vs15 manual Select Image Control

Troubleshooting

Problem	Possible Cause	Solution
Image is not	Position may need	Press the Menu button to
centered.	adjustment.	access the OSD menu.
		Select Image Control/
		Horizontal Position or
		Vertical Position to adjust
		the horizontal or vertical
		position of the image.
“No Connection,	Monitor video cable is	Connect the monitor video
Check Signal Cable”	disconnected.	cable to the VGA connector
displays on screen.		on the computer, or connect
		the DVI-D (select f monitor
		models only) signal cable
		(sold separately) to the DVI
		connector on the computer.
		Be sure that the computer
		power is off while
		connecting the video cable.

“Out of Range.”	Video resolution and
	refresh rate are set
	higher than what your
	monitor supports.

Restart your computer and enter Safe Mode. Change your settings to a supported setting (see the table in “Pre-set Video Modes” in Appendix B). Restart your computer so that the new settings take effect.

A–2 User’s Guide