Setting Up the Monitor
Mounting the Monitor
The monitor panel can be mounted on a wall, a swing arm, or other mounting fixture.
1.If the stand base is attached, follow the procedure in “Removing the Stand Base” at the beginning of this chapter.
ÄCAUTION: Before beginning to disassemble the monitor, be sure the monitor is turned off and the power and signal cables are both disconnected. If your monitor has a connected audio cable, disconnect it.
After the base is removed from the monitor, four threaded mounting holes are exposed on the monitor back panel to be used for mounting purposes. These mounting holes are spaced 100mm apart and are compliant with the Video Electronics Standards Association (VESA) standard for mounting flat panel displays.
ÄCAUTION: This monitor supports the VESA industry standard 100mm mounting holes. To attach a third party mounting solution to the monitor, four 4mm, 0.7 pitch, and 10mm long screws are required (not provided with the monitor). Longer screws should not be used because they may damage the monitor. It is important to verify that the manufacturer’s mounting solution is compliant with the VESA standard and is rated to support the weight of the monitor display panel. For best performance, it is important to use the power and video cable provided with the monitor.
User Guide |