HP ZR30W German Ergonomics Notice, Japanese Notice Korean Notice Power Cord Set Requirements

Page 31

Hewlett-Packard GmbH, HQ-TRE, Herrenberger Strasse 140, 71034 Boeblingen, Germany

The official EU CE declaration of conformity for this device may be found at http://www.hp.com/go/ certificates.

German Ergonomics Notice

HP products which bear the “GS” approval mark, when forming part of a system comprising HP brand computers, keyboards and monitors that bear the “GS” approval mark, meet the applicable ergonomic requirements. The installation guides included with the products provide configuration information.

Japanese Notice

Korean Notice

Power Cord Set Requirements

The monitor power supply is provided with Automatic Line Switching (ALS). This feature allows the monitor to operate on input voltages between 100–120V or 200–240V.

The power cord set (flexible cord or wall plug) received with the monitor meets the requirements for use in the country where you purchased the equipment.

If you need to obtain a power cord for a different country, you should purchase a power cord that is approved for use in that country.

The power cord must be rated for the product and for the voltage and current marked on the product's electrical ratings label. The voltage and current rating of the cord should be greater than the voltage and current rating marked on the product. In addition, the cross-sectional area of the wire must be a minimum of 0.75 mm² or 18 AWG, and the length of the cord must be between 6 feet (1.8 m) and 12 feet (3.6 m). If you have questions about the type of power cord to use, contact an authorized HP service provider.

A power cord should be routed so that it is not likely to be walked on or pinched by items placed upon it or against it. Particular attention should be paid to the plug, electrical outlet, and the point where the cord exits from the product.

ENWW

German Ergonomics Notice 25

Page 30 Page 32
Image 31
Page 30 Page 32
Contents HP ZR30w LCD Monitor Page About This Guide Iv About This Guide Table of contents Appendix a Troubleshooting HP ZR30w Model Product FeaturesImportant Safety Information Safety and Maintenance GuidelinesCleaning the Monitor Maintenance GuidelinesShipping the Monitor Installing the Monitor Pedestal Base Setting Up the MonitorHP ZR30w Model Rear ComponentsRouting and Connecting the Cables Routing and Connecting the Cables Adjusting the Monitor Connecting USB Devices9Adjusting the Height Turning on the Monitor Removing the Monitor Pedestal Base Mounting the Monitor 13Inserting the Monitor Panel into the Quick Release Locating the Rating Labels Installing an HP/Kensington MicroSaver Security Cable LockImage Color Matching File Operating the MonitorSoftware and Utilities Information FileInstalling from the CD Installing the .INF and .ICM FilesDownloading from the Worldwide Web 1Monitor Front Panel Controls Front Panel ControlsDynamic Contrast Ratio DCR Solving Common Problems TroubleshootingOnline Technical Support Preparing to Call Technical Support ZR30w Model Technical SpecificationsEnergy Saver Feature Cables Agency Regulatory NoticesFederal Communications Commission Notice ModificationsAvis Canadien Canadian NoticeEuropean Union Regulatory Notice German Ergonomics Notice Japanese Notice Korean Notice Power Cord Set RequirementsProduct Environmental Notices Japanese Power Cord RequirementsMaterials Disposal Turkey EEE Regulation LCD Monitor Quality and Pixel Policy
Top Page Image Contents