Connection instructions, Installing the display

Connection instructions

Installing the display

Install: Remove:

Place the display on the table (Figure 1)

Packaging procedures

If you need to package the display again, please keep the original carton and packing materials. The procedures for re-packaging the display are as follows:

1.Unplug the power cord from the display (make sure all attached peripherals are already turned off).

2.Put the display into the carton in the original packaging manner.

Important

Before you start, place a clean towel or cloth on a flat surface, on which you can place the removed display panel without being damaged.

Adjusting the viewing angle

You may adjust the display's viewing angle from -5° ~ 20°. (Figure 2)

Note:

•When you adjust the viewing angle of the display, avoid touching the LCD display with your fingers, as this may damage or break the liquid crystal screen.

•When you adjust the angle of your display, pay attention to your adjustment action, as shown in the figure above.