HP Advantage LA2006x 20 XN374A8#ABA, LA2306x 23' C0H31A8#ABA Using the Auto-Adjustment Function

Using the Auto-Adjustment Function

You can optimize the screen performance for the VGA (analog) input by using the OK/auto button on the monitor and the auto-adjustment pattern software utility on the CD provided.

Do not use this procedure if the monitor is using a DVI or DisplayPort input. If the monitor is using a VGA (analog) input, this procedure can correct the following image quality conditions:

●Fuzzy or unclear focus

●Ghosting, streaking or shadowing effects

●Faint vertical bars

●Thin, horizontal scrolling lines

●An off-center picture

To use the auto-adjustment feature:

1.Allow the monitor to warm up for 20 minutes before adjusting.

2.Press the OK/auto button on the monitor front panel.

●You can also press the Menu button, then select Image Control > Auto-Adjustmentfrom the OSD Main Menu. Refer to Adjusting the Monitor Settings on page 20 in this chapter.

●If the result is not satisfactory, continue with the procedure.

3.Insert the CD in the disc drive. The CD menu is displayed.

4.Select Open Auto-Adjustment Software. The setup test pattern is displayed.

5.Press the OK/auto button on the monitor front panel to produce a stable, centered image.

6.Press the ESC key or any other key on the keyboard to exit the test pattern.

18 Chapter 4 Operating the Monitor ENWW