QuickSpecs
HP ProLiant ML115
Technical Specifications
System Unit | Dimensions (HxWxD) | 14.46 x 6.88 x 16.76 in (36.7 x 17.5 x 42.6 cm) |
| |
| (with feet) |
|
|
|
| Weight (approximate) | 23.15 lb (10.5 kg) |
|
|
| Input Requirements | Range Input Voltage | 100 to 127 VAC/200 to 240 VAC | |
| (per power supply) | Normal Line Voltage | 115 or 230 VAC |
|
|
|
| ||
| Line Frequency | 50 to 60 Hz |
|
|
| Rated Input Current | load 8A at 115VAC, 4A at 230VAC |
| |
| BTU Rating | 1907 BTU |
|
|
| SCSI Connectors | One internal LVD/SE connector for U160 devices, plus two internal SE | ||
| (SCSI Models only) | connectors for legacy devices. |
| |
| Power Supply Output | Rated | 370W |
|
| Power (per power supply) | Maximum Peak Power | 370W |
|
| Temperature Range | Operating | 50° to 95° F (10° to 35° C) | |
|
| Shipping | ||
| Relative Humidity | Operating | 10% to 90% |
|
| 10% to 95% |
| ||
|
|
| ||
| Acoustic Noise | Idle |
|
|
|
| (Fixed Disk Drives |
|
|
|
| Spinning) |
|
|
|
| L WAd (BELS) | 5.4 |
|
|
| L pAm (dBA) | 36 |
|
|
| Operating |
|
|
|
| (Random Seeks to Fixed |
|
|
|
| Disks) |
|
|
|
| L WAd (BELS) | 5.9 |
|
|
| L pAm (dBA) | 38 |
|
|
|
|
|
|
HP 160GB 1.5G SATA | 160GB 7,200 rpm | Capacity | 160,041 MB |
|
7.2K NHP 3.5" HDD |
| Height | 1.0 in. (26.1 mm) |
|
|
| |||
| Width | 4.0 in. (101.6 mm) |
| |
|
|
| ||
|
| Interface | Serial ATA |
|
|
| Transfer rate synchronous | 1.5 Gb/s |
|
|
| (maximum) |
|
|
|
| Seek time (typical reads, | Single track | 0.9 ms |
|
| including settling) | Average | 9.0 ms |
|
|
| ||
|
|
| 17.8 ms | |
|
|
| Rotational speed | 7,200 rpm |
|
| Physical Configuration | Bytes/Sector | 512 |
|
|
| Logical Blocks | 312,581,808 |
|
| Operating Temperature | 41° to 131° F (5° to 55° C) | |
|
|
|
|
|
DA - 12704 Worldwide — Version 16 — May 12, 2008 | Page 23 |