HP ML310 manual Standard Features, Processor, Cache Memory One of the following depending on Model

QuickSpecs

HP ProLiant ML310 Generation 3

Standard Features

Processor	Dual-core Intel® Pentium® D 940 (3.2 GHz/800 - 2 x 2MB L2)
One of the following	NOTE: See "Configuration Information - Factory Integrated Models" section
	Dual-core Intel® Pentium® D 930 (3.0 GHz/800 - 2 x 2MB L2)
	Dual-core Intel® Pentium® D 920 (2.8 GHz/800 - 2 x 2MB L2)
	NOTE: See "Configuration Information - Factory Integrated Models" section
	Intel® Pentium® 4 650 (3.4 GHz/800 - 2M L2)
	Intel® Pentium® 4 640 (3.2 GHz/800 - 2M L2)
	Intel® Pentium® 4 630 (3.0 GHz/800 - 2M L2)
	NOTE: See "Configuration Information - Factory Integrated Models" section
	Intel® Celeron D® 331 (2.66 GHz/533 - 256KB L2)

Cache Memory One of the following depending on Model

Integrated 2 x 2MB level 2 ECC cache (Pentium D 900 Series models) Integrated 2 x 1MB level 2 ECC cache (Pentium D 800 Series models) Integrated 2MB level 2 ECC cache (Pentium 4 models)

Integrated 256KB level 2 ECC cache (Celeron D models)

Memory Protection	Advanced ECC
Memory	Type	PC2-4200 unbuffered DDR2 SDRAM (533MHz)
	Standard	512 MB (1 x 512 MB)
	Maximum	8 GB
Network Controller	Embedded NC320i PCIe Gigabit Server Adapter
Expansion Slots	Slot Number	Bus Speed	Maximum Card	Hot Plug	Connector Type
			Length
	4	PCI Express x4	12.3	No	x8
	3	64-bit/100MHz	12.3	No	3.3V
		PCI-X
	2	64-bit/100MHz	12.3	No	3.3V
		PCI-X
	1	PCI Express x1	12.3	No	x1

Storage Controllers One of the following depending on Model

The HP ProLiant ML310 G3 offers both SCSI and Serial models. SCSI models support U320 SCSI hard drives. Serial models support Serial Attached SCSI (SAS) and Serial ATA (SATA) hard drives. Use of SAS hard drives in Serial models requires installation of a SAS controller or HBA.

Single Channel Ultra320 SCSI Adapter (in PCI-X slot) (SCSI Models)

Integrated four port SATA controller with integrated SATA RAID 0, 1 (SATA Models)

NOTE: Use of the embedded SATA RAID feature requires installation of a driver from a floppy drive. The supported floppy drive can be a USB floppy drive, half-height internal floppy drive, or virtual floppy via Integrated Lights-Out 2 (iLO 2).

NOTE: See the "Storage" section of these QuickSpecs for information on controllers and cables required to support SATA and SAS hard drive configurations

DA - 12364 Worldwide QuickSpecs — Version 21 — 2-16-2007 Page 3