HP ACC2 Aurora manual Exposure time, Intensifier gain, Run file, Or the Garmin

12

running in burst mode. The default is normal mode, but the operator can change to burst mode by pressing the Burst option button in the ACC2 window.

When ACC_USE_CONTROL_SEC is 1 in the configuration file : When composing the sequence file the operator must allow the program to read the run file and the timer file or the Garmin GPS 12XL receiver. This is done the ACC_CONTROL_SEC second specified in the configuration file. The ACC2 program needs about 2 seconds to perform these tasks.

When ACC_USE_CONTROL_SEC is 2 in the configuration file: In this case the c$ is used (see below).

f$ is the filter number $ = 1 for 630.0 nm $ = 2 for 557.7 nm $ = 3 for 427.8 nm

e$$$	is	the	exposure time in		milliseconds
g$	is	the	intensifier gain		(0, 1, 2 or	3)
s$	is	save image to		hard disk (1 = yes, 0			= no)
u$	is	save image to		external disk (1 =		yes, 0 =		no)
c$	is read		the run file and		the timer file		or the Garmin
.	GPS 12XL receiver			after the image is		captured		(1 = yes,
.	0 = no)

Example:

#sequence file: x1.seq

#The camaera run either in normal or burst mode

#t* is normal mode (* is seconds in the minute)

#b* is burst mode (* is second in the minute)

#f* is filter number (1: 630.0nm , 2: 557.7 nm, 3: 427.8 nm)

#g* is intensifier gain (0,1,2 or 3)

#e* is exposure time in ms

#s* save to harddisk, 1: yes , 0: no

#u* save to network disk, 1: yes , 0: no

#c* is perform control check after this image , 1: yes, 0: no

#normal mode sequence

t0 f1 g3 e2000 s1 u1 c1

t30 f2 g2 e1000 s1 u0 c0

#

#burst mode sequence b0 f1 g3 e2000 s1 u1 c1

b10 f2 g2 e1000 s1 u0 c0

b20 f1 g3 e2000 s1 u0 c0

b30 f2 g2 e1000 s1 u0 c0

b40 f1 g3 e2000 s1 u0 c0

b50 f2 g2 e1000 s1 u0 c0

#end of file

This example shows the camera should take two images pr. minute in normal mode and six images pr. minute in burst mode. The