Figure 9 Hole spacing
2.Insert one wall anchor into each hole until the anchors are flush with the wall surface.
3.Drive one screw into each wall anchor, and tighten the screws just enough to keep it secure in the wall anchor.
Leave a minimum clearance of 1.5 mm (0.06 in) between the base of the screw head and the wall anchor so the switch can hang on the screws securely.
Figure 10 Driving a screw into a wall anchor
4.Align the two mounting holes in the switch chassis bottom with the two screws on the wall and hang the switch.
Make sure the Ethernet ports are facing downwards and the chassis side panels are perpendicular to the ground.
Figure 11 Wall mounting
(1)Mounting hole in the switch chassis bottom
8