Chart Environmental Chambers | Operation |
NATURAL HEAT RISE IN
30
25
20
15
10
5
0
No live heat load in chamber
0 | 50 | 100 | 150 | 200 | 250 | 300 | 350 | 400 | 450 | 500 |
Time Elapsed (min)
Watlow Series 96 Controller Operation
NOTE: For more complete instructions on the operation of the Watlow Series 96 controller, refer to the supplied manual. All information in the Watlow controller manual takes precedence over information shown in this manual.
Entering Temperature Set Points
The temperature set point for the chamber is displayed on the bottom display of the Watlow controller. The set point is simply entered by using the up and down arrow buttons on the front of the controller. The up arrow is used to increase the set point and the down arrow is used to decrease the set point. If the buttons are pressed once, the set point will change by one degree. If the buttons are pushed and held, the set point will continue changing set point and will change faster as the button is held in longer.
Current chamber temperature.
Current temperature set point.
Increase temperature set point.
Decrease temperature set point.
12