York BP 036 warranty DISCONNECT/BLOWER Access Location Utilities Entry, Minimum Clearances

255027-YTG-B-0507

FILTER

ACCESS

BLOWER MOTOR

ACCESS

DOT PLUGS
FIELD-SUPPLIED
DISCONNECT SWITCH
LOCATION
MOUNTING BRACKET
FOR DICONNECT SWITCH
(Shipped attached to the
blower housing inside
the blower compartment)	A,B
	WIRING ENTRY	CONTROL BOX
	(See Detail “B”)	ACCESS

DISCONNECT SWITCH LOCATION

AND MOTOR ACCESS PANEL FOR

UNIT WITH “BELT-DRIVE” OPTION

FIGURE 7 - DISCONNECT/BLOWER ACCESS LOCATION

TABLE 28: UTILITIES ENTRY

HOLE	OPENING SIZE (DIA.)	USED FOR
A	7/8” KO1	Control Wiring2	Side
			Bottom
B	2” KO1	Power Wiring	Side
			Bottom
C	1-5/8” KO	Gas Piping (Front)
D	1-1/2” KO	Gas Piping (Bottom)

1.Opening in the bottom to the unit can be located by the side in the insulation.

2.Do not remove the 2” knockout ring.

TABLE 29: MINIMUM CLEARANCES

LOCATION	CLEARANCE
Front	24” (Cooling/Electric Heat)
	32” (Gas Heat)
Rear	12” (Less Economizer)
	36” (With Economizer or Fixed
	Air/Motorized Damper)
Left Side (Filter Access)	24” (Less Economizer)
	36” (With Economizer)
Right Side (Cond. Coil)	24”
Below Unit1	0”
Above Unit2	72” (For
	Condenser Air Discharge)

1.Units may be installed on combustible floors made from wood or class A, B, or C roof covering material.

2.Units must be installed outdoors. Overhanging struc- tures or shrubs should not obstruct condenser air dis- charge outlet.

Unitary Products Group 37