HP C6280, C6250 manual Install the software for a network connection

Page 10

Chapter 2

Network setup

3.Connect the other end of the Ethernet cable to an available port on your Ethernet router, switch, or wireless router.

4.Once you have connected the HP All-in-One to the network, install the software as described in “Install the software for a network connection” on page 8.

Install the software for a network connection

Use this section to install the HP All-in-One software on a computer connected to a network. Before you install the software, make sure you have connected the HP All-in- One to a network.

NOTE: If your computer is configured to connect to a series of network drives, make sure that your computer is currently connected to these drives before installing the software. Otherwise, HP All-in-One installation software might try to use one of the reserved drive letters, and you will not be able to access that network drive on your computer.

NOTE: Installation time can range from 20 to 45 minutes depending on your operating system, the amount of available space, and the processor speed of your computer.

To install the Windows HP All-in-One software

1.Quit all applications running on your computer, including any virus detection software.

2.Insert the Windows CD that came with the HP All-in-One into the CD-ROM drive on your computer and follow the onscreen instructions.

3.If a dialog box about firewalls appears, follow the instructions. If you see firewall pop- up messages, you must always accept or allow the pop-up messages.

4.On the Connection Type screen, select Through the network, and then click Next.

The Searching screen appears as the Setup program searches for the HP All-in-One on the network.

8 Network setup

Image 10

Contents HP Photosmart C6200 All-in-One series Hewlett-Packard Company notices Contents HP All-in-One overview HP All-in-One at a glanceControl panel features LabelFind more information Setup Guide Onscreen HelpNetwork setup Wired network setupConnect the HP All-in-One to the network What you need for a wired networkTo connect the HP All-in-One to the network Install the software for a network connection To install the Windows HP All-in-One softwareTo change a USB connection to a wired Ethernet connection Manage your network settingsChange basic network settings from the control panel View and print network settingsSet link speed Restore network defaultsChange IP settings Automatic Full HalfIP Address Subnet Mask Default Gateway Load an original on the glass Use the HP All-in-One featuresLoad originals and load paper Load full-size paperTo load full-size paper Load 10 x 15 cm 4 x 6 inch photo paper To load 10 x 15 cm 4 x 6 inch photo paper in the photo trayAvoid paper jams View and select photosTo view, select, and print photos Scan an imageScan an original to a computer To scan to a computerReplace the ink cartridges Make a copyScan an original to a memory card To replace the ink cartridges Replace the ink cartridges Clean the lid backing Clean the HP All-in-OneClean the glass To clean the glassClean the HP All-in-One Hardware setup troubleshooting Troubleshooting and supportUninstall and reinstall the software HP All-in-One will not turn onSolution HP All-in-One does not print Network troubleshooting Computer is unable to discover the HP All-in-OneClear paper jams Printer not Found screen appears during installationTo make sure your network connection is active To clear a paper jam from the Two-sided printing accessory Information on ink cartridges and the print headIf you have a problem, follow these steps Support processSystem requirements Product specificationsTechnical information Ink cartridge yieldRegulatory notices Regulatory model identification numberWarranty Technical information

Related manuals

Manual 12 pages 45.81 Kb