United States Stove VF30IN, VF30IL manual Wiring Blower Assembly, Wiring Diagram

WIRING BLOWER ASSEMBLY

To locate the blower, open the lower access door and locate the blower cover as shown in FIGURE 7. The blower is located directly behind the blower cover. The blower comes partially pre-wired into the junction box. To complete wiring, run the house power supply into the heater through one of the knockouts located on either side of the firebox. Run house supply into junction box and wire as shown in wiring diagram below(Attach grounding wire to junction box). NOTE: Junction box and bracket comes mounted to the right side (facing unit). You can also mount the junction box on the left side if necessary.

See "Blower replace instructions" supplied with replacement blower to remove blower.

FIGURE 7. Blower Location

NOTE: If any of the original wire must be replaced, it must be replaced with 600 volt, 150 C. wire or its equivalent.

Caution: Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing.

WIRING DIAGRAM

16