HP 3054A e All in One Inkjet CR237A#B1H manual Connectivity, Push Button PBC method

Page 33

8Connectivity

•Wi-Fi Protected Setup (WPS – requires WPS router)

•Traditional wireless connection (requires router)

•USB Connection (non-network connection)

•Change from a USB connection to a wireless network

•Connect a new printer

•Change wireless network settings

•Tips for setting up and using a networked printer

•Advanced printer management tools (for networked printers)

Wi-Fi Protected Setup (WPS – requires WPS router)

These instructions are for customers who have already setup and installed the printer software. For first time installation refer to the setup instructions that came with the printer.

To connect the HP All-in-One to a wireless network using Wi-Fi Protected Setup (WPS), you will need the following:

￿A wireless 802.11b/g/n network that includes a WPS-enabled wireless router or access point.

NOTE: 802.11n will only support 2.4Ghz

￿A desktop computer or laptop with either wireless networking support, or a network interface card (NIC). The computer must be connected to the wireless network that you intend to install the HP All-in-One on.

NOTE: If you have a Wi-Fi Protected Setup (WPS) router with a WPS push button, follow the Push Button method. If you are not certain your router has a push button, follow the Wireless Settings Menu method.

Push Button (PBC) method

1.Press the Wi-Fi Protected Setup (WPS) button on your router.

2.Press and hold the Wireless button on the printer until the wireless light starts blinking. Press and hold for 3 seconds to start WPS push button mode .

NOTE: The product begins a timer for approximately two minutes while a wireless connection is established.

Wireless Settings Menu method

1.Press the Wireless button on the printer to display the Wireless menu. If the printer is printing, in an error state, or performing a critical task, wait until the task has been completed or the error cleared before pressing the Wireless button.

2.Select Wireless Settings from the printer display.

3.Select Wi-Fi Protected Setup from the printer display.

4.If you have a Wi-Fi Protected Setup (WPS) router with a WPS push button, select Push Button, and then follow the onscreen instructions. If your router does not have a push button or you are not certain if your router has a push button, select PIN, and then follow the onscreen instructions.

NOTE: The product begins a timer for approximately two minutes during which the corresponding button on the networking device needs to be pressed or the router PIN needs to be entered on the router’s configuration page.

Connectivity 31

Page 32 Page 34
Image 33
Page 32 Page 34
Contents HP Deskjet 3050A J611 series Page Contents Regulatory notices How Do I? Chapter How Do I? Printer parts Get to know the HP All-in-OneWireless Settings Control panel featuresStatus Lights From the Wireless Menu, select SettingsTo change Auto Power-Off setting Auto Power-OffPrint Print photosTo print a photo on photo paper To print a document Print documentsPrint envelopes Print Quick FormsTips for print success Print Quick FormsPrinter settings tips Ink tipsPaper loading tips To print in Maximum dpi mode Print using the maximum dpiChapter Print EPrint from anywhere EPrint from anywhereTo ePrint a document from anywhere Chapter EPrint from anywhere Recommended papers for printing Paper basicsLoad media Load small-size paper Load envelopes Load media Chapter Paper basics Copy and scan CopyEasy Copy More copy features Scan to a computerPrepare the scan Scan from your computer Scan from the printer control panelTips for scan success Tips for copy successWork with cartridges Check the estimated ink levelsOrder ink supplies Replace the cartridges Choose the right cartridges Locate the cartridge number in the Printer Software Related topicsReplace the cartridges Cartridge warranty information Use single-cartridge modeWireless Settings Menu method Wi-Fi Protected Setup WPS requires WPS routerConnectivity Push Button PBC methodTraditional wireless connection requires router Change from a USB connection to a wireless networkUSB Connection non-network connection Tips for setting up and using a networked printer Change wireless network settingsConnect a new printer Advanced printer management tools for networked printersTo open the embedded Web server To print a diagnostics Solve a problemImprove print quality To align the cartridges from the Printer SoftwareClear a paper jam To clean the cartridges automaticallyTo clear a paper jam Input trayInside of printer Output trayTo verify that the product is set as the default printer Resolve print issuesUnable to print Prevent paper jamsClear the print carriage Ink cartridge problem Prepare the traysPrinter failure Ink cartridge problem If you have a problem, follow these steps NetworkingHP support Additional warranty options Chapter Solve a problem System requirements Environmental specifications SpecificationsTechnical information Input tray capacityPrint specifications Paper weightsCopy specifications Scan specificationsEnvironmental product stewardship program Sleep mode Power consumptionRecycling program HP inkjet supplies recycling programRegulatory notices Regulatory model identification number European Union Regulatory Notice Products with wireless LAN devicesFrance Regulatory wireless statementsRegulatory notices Chapter Technical information Index
Top Page Image Contents