HP F100 IP address, Logical unit number, Microsoft Cluster Server/Service, MSAFlash utility

Page 41

Glossary 41

IP address

Internet Protocol address. An address assigned to a network interface card, which computer entities use to locate and communicate with each other. IP addresses can be statically or dynamically assigned.

logical unit

Commonly called a LUN (which is the acronym for logical unit number). A physical or virtual device addressable through a target ID number. Logical units use the target bus connection to communicate on the SCSI bus. The host sees a virtual disk as a logical unit.

logical unit number

1.A value that identifies a specific logical unit belonging to a SCSI target ID number. LUN is commonly used in reference to a logical unit.

2.A number associated with a physical device unit during the I/O operations of a task. Each task in the system must establish its own correspondence between logical unit numbers and physical devices.

Microsoft Cluster Server/Service

The software needed for clustering servers.

MSAFlash utility

An HP utility that can be used to upgrade the firmware of the MSA1000, environmental monitoring unit, and the MSA Fabric Switch 6.

network interface controller

A board that enables a computer to be connected to a network and that works with the network operating system to control the flow of information over the network.

node

An individual server in a cluster.

Image 41
Contents HP ProLiant Cluster F100 Installation Guide Audience Assumptions Contents Technical Support This Section Overview of the HP ProLiant Cluster F100F100 Cluster Components Guidelines for Multiple Clusters HP StorageWorks Storage Systems HP ProLiant ServersHost Bus Adapters HP StorageWorks SAN SwitchesHP StorageWorks Controllers Client Network Optical TransceiversCluster Interconnect Redundant Interconnects Private or Public InterconnectInterconnect Adapters Cluster Interconnect CablesServer to Storage Network Interconnect Microsoft SoftwareProLiant Support Packs Array Configuration UtilityHP SmartStart CD Systems Insight Manager Resources for Application InstallationHP Modular Smart Array 1000 Support Software CD Overview of the HP ProLiant Cluster F100 Page Preinstallation Overview Setting Up the HP ProLiant Cluster F100Preinstallation Guidelines Setting Up the HP ProLiant Cluster F100 Setting Up the Nodes Installing the HardwareInstalling the Cluster Interconnect Installing Host Bus AdaptersSetting Up a Dedicated Interconnect Setting Up the Storage SystemPowering Up Configuring Shared StorageEthernet Direct Connect Using a Switch or Hub Setting Up a Public InterconnectEthernet Direct Connect Using a Crossover Cable Redundant Interconnect Installing the SoftwareMultiple Cluster Setup SmartStart Installation Installing the Node 1 Operating System Cluster-Specific SmartStart InstallationSmartStart Installation Steps Setting Up the HP ProLiant Cluster F100 HP ProLiant Cluster F100 Installation Guide Installing the Node 2 Operating System Validating the Cluster HP Contact Information Technical SupportBefore You Contact HP HP ProLiant Cluster F100 Installation Guide HBA Acronyms and AbbreviationsPnP MSA1000MSA1000 Controller RA4100 RA4000 ControllerPage Glossary Disk group Dedicated interconnectDriver EthernetFailover cluster Fault toleranceFibre Channel Gigabit Interface Converter-ShortwaveHP StorageWorks Modular Smart Array Host bus adapterHP StorageWorks Modular Smart Array 1000 Controller HP StorageWorks RAID Array 4000 ControllerIP address Microsoft Cluster Server/ServiceLogical unit Logical unit numberNT File System Power-On Self-TestPartition PortRedundant Array of Inexpensive Disks RedundancyReliability ResourceTransmission Control Protocol/Internet Protocol SystemIndex Storage system, set up