Specifications
Heating Specifications
Input Rating | 38,500 | BTU/hr |
Heat Output1 | 30,000 | BTU/hr. |
Efficiency | 78% |
|
Heating Capacity2 | 850 sq. ft. | |
Fuel Burn Rate3 | 3.5 lbs./hr. ±5% | |
Burn Time (lowest setting) | ||
Hopper Capacity | 40 lbs. |
|
|
|
|
1BTU output will vary depending on the quality of fuel. Use PFI listed fuels for the best results.
2Heating capacity will vary depending on floor plan layout of your home, degree of insulation, and the outside temperature.
3Pellet size may effect the actual rate of fuel feed and burn times. Fuel feed rates may vary by as much as 20%. Use PFI listed fuel for best results.
Dimensions
Height
Width
Depth
Electrical Specifications
Electrical Rating | |
|
|
Watts (maximum) | 520 (approx.) |
|
|
FUEL CONSIDERATIONS
Your Pellet stove is designed to burn premium hardwood pellets that comply with Association of Pellet Fuel Industries standards. (Minimum of 40 lbs density per cubic ft, 1/4” to 5/16” diameter, length no greater than 1.5”, not less than 8,200 BTU/lb, moisture under 8% by weight, ash under 1% by weight, and salt under 300 parts per million). Pellets that are soft, that contain excessive amounts of loose sawdust, or that have been or are wet will result in reduced performance. Due to the different fuel densities and sizes, the fuel feed rate may vary. This may require an adjustment to the slider damper setting or the auger feed trim setting on low.
SAFETY AND EPA COMPLIANCE
Your Pellet stove has been safety tested and listed to ASTM E 1509, by
4 | USSC |