HP Z22i manual Removing the Monitor Stand

Page 21

Removing the Monitor Stand

You can remove the monitor panel from the stand to install the panel on a wall, a swing arm, or other mounting fixture.

CAUTION: Before beginning to disassemble the monitor, be sure the monitor is turned off and the power and signal cables are both disconnected. Also disconnect all USB cables connected to the monitor.

1.Disconnect and remove the signal, power, and USB cables from the monitor.

2.Lay the monitor face down on a flat surface covered by a clean, dry cloth.

3.Pivot the stand 45 degrees clockwise and remove the lower right mounting screw from the back of the monitor, then pivot the stand 45 degrees counter-clockwise and remove the lower left mounting screw from the back of the monitor.

4.Remove the two upper mounting screws (1) then lift the stand off the monitor (2).

Removing the Monitor Stand 15

Page 20 Page 22
Image 21
Page 20 Page 22
Contents HP Z22i and Z23i IPS Displays First Edition March Document Part Number About This Guide Iv About This Guide Table of contents Page HP IPS Monitors Product FeaturesPage Unfolding the Monitor Setting Up the MonitorComponent Function Rear ComponentsConnecting the Cables Page Page Page Control Function Front Panel ControlsAdjusting the Monitor Page Turning on the Monitor HP Watermark and Image Retention Policy Connecting USB Devices Removing the Monitor Stand Mounting the Monitor Locating the Rating Labels Installing a Cable LockFinding More Information Reference GuidesProduct Support Technical Specifications Z22i ModelZ23i Model Z22i Model Recognizing Preset Display ResolutionsZ23i Model Entering User ModesEnergy Saver Feature
Top Page Image Contents