HP V241 23.6-inch manual Agency Regulatory Notices, Modifications, Cables

Page 22

B Agency Regulatory Notices

Federal Communications Commission Notice

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio or television technician for help.

Modifications

The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by HP may void the user's authority to operate the equipment.

Cables

To maintain compliance with FCC Rules and Regulations, connections to this device must be made with shielded cables having metallic RFI/EMI connector hoods.

Declaration of Conformity for products marked with the FCC logo

(United States only)

This device complies with Part 15 of the FCC Rules. Operation is subject to the following 2 conditions:

1.This device may not cause harmful interference.

2.This device must accept any interference received, including interference that may cause undesired operation.

If you have questions about the product that are not related to this declaration, write to Hewlett-Packard Company

P. O. Box 692000, Mail Stop 530113 Houston, TX 77269-2000

For questions regarding this FCC declaration, write to Hewlett-Packard Company

P. O. Box 692000, Mail Stop 510101 Houston, TX 77269-2000

or call HP at 281-514-3333

To identify your product, refer to the part, series, or model number located on the product.

21

Image 22
Contents HP V241a/V241 LED Backlit Monitor User Guide Page Chapter I. Introduction FeaturesCheck list Chapter II. Installation Install the pedestalConnect your monitor to your computer Disconnect the pedestal for shipping Chapter III.Monitor overview Overview of front panel controlsMenu features Power ON/OFF SwitchPower indicator Chapter IV. Operational InstructionOSD operational instructions Characters only applicable to VGA Button. The factory default setting is Contrast and color temperature, on Exit Factory preset display mode Chapter V. Technical InformationProduct specifications Signal cable connector VGA InterfacePIN Signal DVI InterfacePanel testing Audio interface(Only for V241a)Safety and Maintenance Guidelines Important Safety InformationSafety Precautions Cleaning your monitor Maintenance GuidelinesShipping the monitor Modifications Agency Regulatory NoticesCables Canadian Notice Product Environmental Notices Energy Starr QualificationPage Troubleshooting Solving common problemsPreparing to Call Technical Support Contacting SupportLocating the Rating Label