HP V241 23.6-inch manual Canadian Notice

Page 23

Canadian Notice

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations. CAN ICES-3(B)/NMB-3(B)

Avis Canadien

Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.

European Union Regulatory Notice

Products bearing the CE marking comply with one or more of the following EU Directives as may

be applicable:

Low Voltage Directive 2006/95/EC; EMC Directive 2004/108/EC; Ecodesign Directive 2009/125/EC; R&TTE Directive 1999/5/EC; RoHS Directive 2011/65/EU

Compliance with these directives is assessed using applicable European Harmonised Standards. The full Declaration of Conformity can be found at the following web site: http://www.hp.eu/certificates

(Search with the product model name or its Regulatory Model Number (RMN), which may be found on the regulatory label.)

The point of contact for regulatory matters is Hewlett-Packard GmbH, Dept./MS:HQ-TRE, Herrenberger Strasse 140, 71034 Boeblingen, GERMANY.

German Ergonomics Notice

HP products which bear the “GS” approval mark, when forming part of a system comprising HP brand computers, keyboards and monitors that bear the “GS” approval mark, meet the applicable ergonomic requirements. The installation guides included with the products provide configuration information.

Power Cord Set Requirements

The monitor power supply is provided with Automatic Line Switching (ALS). This feature allows the monitor to operate on input voltages between 100–120V or 200–240V.

The power cord set (flexible cord or wall plug) received with the monitor meets the requirements for use in the country where you purchased the equipment.

If you need to obtain a power cord for a different country, you should purchase a power cord that is approved for use in that country.

The power cord must be rated for the product and for the voltage and current marked on the product's electrical ratings label. The voltage and current rating of the cord should be greater than the voltage and current rating marked on the product. In addition, the cross-sectional area of the wire must be a minimum of 0.75 mm² or 18 AWG, and the length of the cord must be between 6 feet (1.8 m) and 12 feet (3.6 m).If you have questions about the type of power cord to use, contact

22

Image 23
Contents HP V241a/V241 LED Backlit Monitor User Guide Page Check list FeaturesChapter I. Introduction Install the pedestal Chapter II. InstallationConnect your monitor to your computer Disconnect the pedestal for shipping Overview of front panel controls Chapter III.Monitor overviewChapter IV. Operational Instruction Power ON/OFF SwitchPower indicator Menu featuresOSD operational instructions Characters only applicable to VGA Button. The factory default setting is Contrast and color temperature, on Exit Chapter V. Technical Information Factory preset display modeProduct specifications VGA Interface Signal cable connectorDVI Interface PIN SignalAudio interface(Only for V241a) Panel testingImportant Safety Information Safety and Maintenance Guidelines Safety Precautions Shipping the monitor Maintenance GuidelinesCleaning your monitor Cables Agency Regulatory NoticesModifications Canadian Notice Energy Starr Qualification Product Environmental NoticesPage Solving common problems TroubleshootingLocating the Rating Label Contacting SupportPreparing to Call Technical Support