HP P231 manual Adjusting the Monitor, Turning on the Monitor

Page 15

Adjusting the Monitor

Tilt the monitor panel forward or backward to set it to a comfortable eye level.

Turning on the Monitor

1.Press the power button on the computer to turn on the computer.

2.Press the power button on the front of the monitor to turn on the monitor.

CAUTION: Burn-in image damage may occur on monitors that display the same static image on screen for a prolonged period of time.* To avoid burn-in image damage on the monitor screen, you should always activate a screen saver application or turn off the monitor when it is not in use for a prolonged period of time. Image retention is a condition that may occur on all LCD screens. Monitors with a “burned-in image” are not covered under the HP warranty.

* A prolonged period of time is 12 consecutive hours of non-use.

NOTE: If pressing the power button has no effect, the power button lockout feature may be enabled. To disable this feature, press and hold the monitor power button for 10 seconds.

NOTE: You can disable the power LED in the OSD menu. Press the Menu button on the front of the monitor, then select Management > Bezel Power LED > Off.

When the monitor is powered on, a monitor status message is displayed for five seconds. The message shows which input (DVI or VGA) is the current active signal, the status of the auto-switch source setting (on or off; factory default is on), the default source signal (factory default is VGA), the current preset display resolution, and the recommended preset display resolution.

The monitor automatically scans the signal inputs for an active input and uses that input for the display. If two or more inputs are active, the monitor will display the default input source. If the default source is not one of the active inputs, then the monitor will display the highest ranking priority input in the following order: DVI then VGA. You can change the default source in the OSD by pressing the front panel Menu button and selecting Input Control > Default Input.

Adjusting the Monitor

9

Image 15
Contents User Guide Second Edition June Document Part Number About This Guide Iv About This Guide Table of contents Page Product Features Page Attaching the Monitor Base Setting Up the MonitorComponent Function Rear ComponentsConnecting the Cables Page Page 1Monitor Front Panel Controls Front Panel ControlsTurning on the Monitor Adjusting the MonitorLocating the Rating Labels Installing a Cable LockProduct Support Finding More InformationTechnical Specifications Preset Display Resolutions Entering User Modes Energy Saver Feature