Sharp PG-D3510X Auto Sync Auto Sync Adjustment, Auto Power Off Function, Auto Restart Function

Adjusting the Projector Function (“PRJ-ADJ1/2” Menu)

QPRJ-ADJ1

		Pict. SIG		SCR PRJ-ADJ1 PRJ2	Net.
1		Auto Sync		On
2		Auto Power Off		On
3		Auto Restart		On
4		Speaker		On
5		RS-232C		9600bps
6		Fan Mode		Normal
7		System Lock		Disable
8		Keylock		Off
		SEL./ADJ.		ENTER	END
1 Auto Sync (Auto Sync
		Adjustment)
Selectable				Description
	items
On			Auto Sync adjustment will occur when
			the projector is turned on or when the
			input signals are switched, when
			connected to a computer.
Off			Auto Sync adjustment is not
			automatically performed.

Note

•Auto Sync adjustment is also performed by pressing AUTO SYNC.

•The Auto Sync adjustment may take some time to complete, depending on the image of the computer connected to the projector.

•When the optimum image cannot be achieved with Auto Sync adjustment, use manual adjustments. (See page 45.)

2 Auto Power Off Function

Selectable	Description
items
On	When no input signal is detected for
	more than 15 minutes, the projector will
	automatically enter Standby mode.
Off	The Auto Power Off function will be
	disabled.

Note

•When the Auto Power Off function is set to “On”, 5 minutes before the projector enters Standby mode, the message “Enter STANDBY mode in X min.” will appear on the screen to indicate the remaining minutes.

Menu operation n Page 40

QPRJ-ADJ2

			Pict.	SIG	SCR	PRJ1	PRJ-ADJ2 Net.
9			Quick Start Menu				On
0			COMPUTER2 Select				Monitor Output
			FUNCTION Button				Input Search
			STANDBY Mode				Quick Start
			DLP® Link TM				Off
			DLP® Link TM Invert
			All Reset
			Lamp Timer(Life)		0	h	0 min 100%
			SEL./ADJ.			ENTER	END
	3 Auto Restart Function
Selectable						Description
		items
On				If the power cord is unplugged from the
				outlet or the breaker switch is turned off
				when the projector is on, then the
				projector automatically turns on when
				the power cord is plugged into the AC
				outlet or the breaker switch is turned on.
Off				The projector does not turn on
				automatically when the power cord is
				plugged into the AC outlet or the
				breaker switch is turned on.
	4 Speaker Setting
Selectable						Description
		items
On				The audio signal is output from the
				internal speaker.
Off				The audio signal is not output from the
				internal speaker.

5 Selecting the Transmission

Speed (RS-232C)

Make sure that both the projector and computer are set for the same baud rate.

Selectable	Description
items

9600bps Transmission speed is slow.

38400bps

115200bps Transmission speed is rapid.

50