Sharp PG-D3010X Setting the Video Setup, When reproducing Ntsc signals in PAL video equipment

Signal Adjustment (“SIG-ADJ” Menu) (Continued)

	Menu operation n Page 40
4 Setting the Video System	6 Checking the Input Signal

The video input system mode is factory preset to “Auto”; however, a clear picture from the connected audio-visual equipment may not be received, depending on the Video signal difference.

In that case, switch the Video signal.

Selectable items

Auto

PAL

SECAM

*NTSC4.43

NTSC3.58

PAL-M

PAL-N

PAL -60

*When reproducing NTSC signals in PAL video equipment.

Note

•The Video signal can only be set in S-VIDEO or VIDEO mode.

•When “Video System” is set to “Auto”, you may not receive a clear picture due to signal differences. Should this occur, switch to the video system of the source signal.

This function allows you to check the current input signal information.

5 Setting the Video Setup

Selectable	Description
items
0 IRE	Sets the black level to 0 IRE.
7.5 IRE	Sets the black level to 7.5	IRE.

Note

•This function is available for the following signals.

With COMPUTER/COMPONENT 1 or 2 input: - 480I

With S-VIDEO or VIDEO input: - NTSC3.58

46