Image Projection (Continued)

Switching the Input Mode

Select the appropriate Input mode for the connected equipment.

Press INPUT / to display the INPUT list.

Use INPUT / to select the Input mode, and use O/Q to select the audio input terminal.

INPUT buttons

AV MUTE button

VOL +/– (Volume) buttons

O/Q buttons

Adjusting the Volume

Press VOL +/– on the remote control or O/Q+ on the projector to adjust the volume.

Note

• Pressing VOL–/–O will lower the volume.

• Pressing VOL+/Q+ will raise the volume.

• When the projector is connected to external

equipment, the volume level of the external

 

equipment changes in accordance with the

 

volume level of the projector. Set the projector's

 

volume to the lowest level when turning the

 

projector on/off or when changing the input signal.

On-screen display

• When you do not want to output the sound

 

from the projector's speaker while the

 

projector is connected to external equipment,

 

set “Speaker” in the “PRJ-ADJ1” menu to

 

“Off”. (See page 50.)

 

 

 

 

 

Displaying the Black Screen

and Turning Off the Sound

Temporarily

Press AV MUTE on the remote control or close the lens shutter to temporarily display a black screen and turn off the sound.

On-screen display

Note

Pressing AV MUTE again will turn the projected image back on.

When you close the lens shutter, the projector will be set to AV Mute mode and then the projector will be turned off automatically after about 30 minutes.

30

Page 34
Image 34
Sharp PG-D2710X, PG-D3510X, PG-D3010X appendix Switching the Input Mode, Adjusting the Volume, On-screen display