HP LD4730 47-inch Micro-Bezel Video Wall Display manual Color Temperature Command k u

Page 17

[t][][Set ID][][OK][Data][x]

15. Color Temperature (Command: k u)

To adjust the screen color temperature.

Transmission

[k][u][][Set ID][][Data][][Red gain][][Green gain][][Blue gain][Cr]

[Data]	0: 9300K

	1: 8000K

	2:	6500K

	3:	User

When Data is 3, specify R, G, B gains:

[Red gain]	00H — FFH


[Green gain]	00H — FFH


[Blue gain]	00H — FFH

Acknowledgement

[u][][Set ID][][OK][Data][][Red gain][][Green gain][][Blue gain][x]

16. Abnormal state (Command: k z)

Abnormal State: Used to Read the power off status when Stand-by mode.

Transmission

[k][z][][Set ID][][Data][Cr]

[Data]	FF: Read

ENWW	Transmission/Receiving Protocol 11

Image 17

Contents Command Reference Guide First Edition January Document Part Number About This Guide Iv About This Guide Table of contents Scheduling Input select Command f u Main Picture Input RS-232-C configurations Command referenceCommunication parameter Command reference listCommand reference list Transmission/Receiving Protocol Power Command k a Local Dimming Command j a Input Select Command k b Main Picture InputAspect Ratio Command k c Main picture format Volume Control Command k f Backlight Command m g Ambient Light Sensor Command j b Contrast Command k g Brightness Command k h OSD Select Command k l Display Name Command v aSharpness Command k k Balance Command k t Remote Lock/Key Lock Command k mAbnormal state Command k z Color Temperature Command k uAuto Configure Command j u ISM Method Command j pTile H Position Command d e Key Command m cSubnet mask, NSM setup Command v l Tile V Monitors Command d h Tile V Position Command d fTile H Monitors Command d g Natural Mode In Tile Mode Command d j Display Location Command v bPlayer Name Command v d Picture Mode Command dSound Mode Command d y Thermal value Command d n Operating time Command d lDhcp VOE Command v e LED fault Check Command d pTime Command f a Speaker Command dOn Timer On/Off Timer Time Command f d Off Timer On/Off Timer Time Command f e Enww Input Scheduling Input select Command f u Main Picture InputPower On Delay Command f h IP Address, VOE Setup Command v fAuto Detection Command f g DPM Select Command f j Language Command fEnergy saving Command f Reset Command f k48. S/W Version Command f z Subnet mask, VOE Setup Command v gSerial no. Check Command f y Check VOE availability Command v IP Address, NSM setup Command v kMac Address, VOE Setup Command v h Mac Address, NSM setup Command v j

Related manuals

Manual 72 pages 20.78 Kb