HP LD4730 47-inch Micro-Bezel Video Wall Display manual Reset Command f k, Energy saving Command f

Page 32

[Data]

0: Off

 

 

 

1: On

 

 

 

2: VGA only

 

 

Acknowledgement

[j][][Set ID][][OK/NG][Data][x]

44. Reset (Command: f k)

Execute the Factory Reset function.

Transmission

[f][k][][Set ID][][Data][Cr]

[Data]

2: Factory Reset

 

 

Acknowledgement

[k][][Set ID][][OK/NG][Data][x]

45. Energy saving (Command: f I)

To set the energy saving mode.

Transmission

[f][I][][Set ID][][Data][Cr]

[Data]

0: Off

 

 

 

1: Level 1

 

 

 

2: Level 2

 

 

 

3: Level 3

 

 

Acknowledgement

[I][][Set ID][][OK/NG][Data][x]

26 Command reference

ENWW

Image 32
Contents Command Reference Guide First Edition January Document Part Number About This Guide Iv About This Guide Table of contents Scheduling Input select Command f u Main Picture Input Command reference RS-232-C configurationsCommand reference list Communication parameterCommand reference list Transmission/Receiving Protocol Power Command k a Local Dimming Command j a Input Select Command k b Main Picture InputAspect Ratio Command k c Main picture format Backlight Command m g Volume Control Command k fAmbient Light Sensor Command j b Contrast Command k gBrightness Command k h OSD Select Command k l Display Name Command v aSharpness Command k k Remote Lock/Key Lock Command k m Balance Command k tColor Temperature Command k u Abnormal state Command k zISM Method Command j p Auto Configure Command j uTile H Position Command d e Key Command m cSubnet mask, NSM setup Command v l Tile V Monitors Command d h Tile V Position Command d fTile H Monitors Command d g Display Location Command v b Natural Mode In Tile Mode Command d jPlayer Name Command v d Picture Mode Command dSound Mode Command d y Operating time Command d l Thermal value Command d nLED fault Check Command d p Dhcp VOE Command v eSpeaker Command d Time Command f aOn Timer On/Off Timer Time Command f d Off Timer On/Off Timer Time Command f e Enww Scheduling Input select Command f u Main Picture Input InputPower On Delay Command f h IP Address, VOE Setup Command v fAuto Detection Command f g Language Command f DPM Select Command f jReset Command f k Energy saving Command f48. S/W Version Command f z Subnet mask, VOE Setup Command v gSerial no. Check Command f y Check VOE availability Command v IP Address, NSM setup Command v kMac Address, VOE Setup Command v h Mac Address, NSM setup Command v j
Related manuals
Manual 72 pages 20.78 Kb