HP LD4730 47-inch Micro-Bezel Video Wall Display manual ISM Method Command j p

Page 18

Acknowledgement

[z][][Set ID][][OK][Data][x]

[Data]

0: Normal (Power on and signal exist)

1:No signal (Power on)

2:Turn the display off by remote control

3:Turn the display off by sleep time function

4:Turn the display off by RS-232-C function

8:Turn the display off by off time function

9:Turn the display off by auto off function

17.ISM Method (Command: j p)

Used to select the afterimage preventing function.

Transmission

[j][p][][Set ID][][Data][Cr]

[Data]	1H: Inversion

	2H: Orbiter

	4H: White Wash

	6H: Dot wash

	8H: Off

Acknowledgement

[p][][Set ID][][OK][Data][x]

18. Auto Configure (Command: j u)

To adjust picture position and minimize image shaking automatically. It works only in RGB (PC) mode.

Transmission

[j][u][][Set ID][][Data][Cr]

12 Command reference

ENWW

Image 18

Contents Command Reference Guide First Edition January Document Part Number About This Guide Iv About This Guide Table of contents Scheduling Input select Command f u Main Picture Input Command reference RS-232-C configurationsCommand reference list Communication parameterCommand reference list Transmission/Receiving Protocol Power Command k a Input Select Command k b Main Picture Input Aspect Ratio Command k c Main picture formatLocal Dimming Command j a Backlight Command m g Volume Control Command k fContrast Command k g Brightness Command k hAmbient Light Sensor Command j b Display Name Command v a Sharpness Command k k OSD Select Command k l Remote Lock/Key Lock Command k m Balance Command k tColor Temperature Command k u Abnormal state Command k zISM Method Command j p Auto Configure Command j uKey Command m c Subnet mask, NSM setup Command v lTile H Position Command d e Tile V Position Command d f Tile H Monitors Command d gTile V Monitors Command d h Display Location Command v b Natural Mode In Tile Mode Command d jPicture Mode Command d Sound Mode Command d yPlayer Name Command v d Operating time Command d l Thermal value Command d nLED fault Check Command d p Dhcp VOE Command v eSpeaker Command d Time Command f aOn Timer On/Off Timer Time Command f d Off Timer On/Off Timer Time Command f e Enww Scheduling Input select Command f u Main Picture Input InputIP Address, VOE Setup Command v f Auto Detection Command f gPower On Delay Command f h Language Command f DPM Select Command f jReset Command f k Energy saving Command fSubnet mask, VOE Setup Command v g Serial no. Check Command f y48. S/W Version Command f z IP Address, NSM setup Command v k Mac Address, VOE Setup Command v hCheck VOE availability Command v Mac Address, NSM setup Command v j

Related manuals

Manual 72 pages 20.78 Kb