HP L5006tm Touchscreen manual Identifying Monitor Conditions, Power Management System, 2OSD Menu

Table 4-2OSD Menu (continued)

Icon	OSD Control	Description
	OSD Language	Selects the language in which the OSD menu is displayed.
	Information Description	Indicates the current resolution, H-Frequency and V-Frequency.

NOTE: When adjusting the Clock and Clock Phase values, if the monitor images become distorted, continue adjusting the values until the distortion disappears. To restore the factory settings, select the Recall Defaults menu in the on-screen display.

Identifying Monitor Conditions

Special messages will appear on the monitor screen when identifying the following monitor conditions:

●Out of Range—Indicates the monitor does not support the input signal because the resolution and/ or refresh rate are set higher than the monitor supports.

●No Input Signal—Indicates the monitor is not receiving a video signal from the PC on the monitor video input connector. Check to determine if the PC or input signal source is off or in the power saving mode.

●Check Video Cable—Indicates the video cable is not properly connected to the computer.

Power Management System

The monitor is equipped with the power management function which automatically reduces the power consumption when not in use.

Mode	Power Consumption
On	<30 W
Sleep	<4 W
Off	<2 W

It is recommended that you switch the monitor off when it is not in use for a long period of time.

NOTE: The monitor automatically goes through the power management system steps when it is idle. To release the monitor from the power management system, press any key on the keyboard or move the mouse or touch the touchscreen. In order for the touchscreen to bring the monitor from the power management system, the touchscreen function must be fully operational.

Monitor models using the APR driver do not support standby or sleep mode.

14 Chapter 4 Operating the Monitor ENWW