HP LE1711 17-inch C Agency Regulatory Notices, Federal Communications Commission Notice, Cables

Page 38

C Agency Regulatory Notices

Federal Communications Commission Notice

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

●Reorient or relocate the receiving antenna.

●Increase the separation between the equipment and the receiver.

●Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

●Consult the dealer or an experienced radio or television technician for help.

Modifications

The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by Hewlett Packard Company may void the user's authority to operate the equipment.

Cables

Connections to this device must be made with shielded cables with metallic RFI/EMI connector hoods to maintain compliance with FCC Rules and Regulations.

Declaration of Conformity for Products Marked with the FCC Logo (United States Only)

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1.This device may not cause harmful interference.

2.This device must accept any interference received, including interference that may cause undesired operation.

For questions regarding the product, contact:

30 Appendix C Agency Regulatory Notices

Image 38

Contents HP LE1711 and LE1911 LCD Monitors User Guide2009 Hewlett-Packard Development Company, L.P First Edition September Document Part NumberAbout This Guide iv About This Guide 2 Safety and Maintenance Guidelines Table of contents1 Product Features 3 Setting Up the MonitorAppendix C Agency Regulatory Notices Appendix A TroubleshootingAppendix B Technical Specifications Appendix D LCD Monitor Quality and Pixel Policy Turkey EEE RegulationPage 1 Product Features HP LCD MonitorsIntelligent Management AssetControl Compliant with the following regulated specifications2 Chapter 1 Product Features European Union CE Directives Swedish TCO Requirements2 Safety and Maintenance Guidelines Important Safety InformationShipping the Monitor Maintenance GuidelinesCleaning the Monitor 3 Setting Up the Monitor Attaching the Monitor BaseConnecting the Cables Rear ComponentsAdjusting the Monitor Turning on the MonitorUsing the Accessory Rails Mounting the Monitor Panel5. Reconnect the cables to the monitor panel Figure 3-7 Installing the Monitor on a Swing ArmFigure 3-6 Removing the Pedestal Base Mounting the Monitor PanelInstalling a Cable Lock Locating the Rating LabelsThe Information File 4 Operating the MonitorSoftware and Utilities The Image Color Matching FileInstalling from the CD Installing the .INF and .ICM FilesUsing the Auto-Adjustment Function 3. Select Install Monitor Driver SoftwareIf the result is not satisfactory, continue with the procedure To use the auto-adjustment feature1. Allow the monitor to warm up for 20 minutes before adjusting Using the Auto-Adjustment FunctionTable 4-1 Monitor Front Panel Controls Front Panel Controls14 Chapter 4 Operating the Monitor ControlAdjusting the Monitor Settings Using the On-Screen Display MenuIcon OSD Menu SelectionsTable 4-2 OSD Menu Main MenuTable 4-2 OSD Menu continued Optimizing Digital Conversion Using the HP Display Assistant Utility Identifying Monitor ConditionsSleep Timer Mode HP Display LiteSaver Installing the HP Display LiteSaver Software2. Select Install HP Display LiteSaver Software sRGB Support Changing the Color Temperature4. Click the Advanced Settings button Installing the sRGB ICM File for Microsoft Windows Vista2. Click Personalization 3. Click Display Settings Problem A TroubleshootingSolving Common Problems SolutionPower Button Lockout is displayed Online Technical Support Preparing to Call Technical SupportTable B-1 LE1711 Specifications B Technical SpecificationsLE1711 Model Table B-1 LE1711 Specifications continued LE1911 Model28 Appendix B Technical Specifications Table B-2 LE1911 SpecificationsEntering User Modes Recognizing Preset Display ResolutionsEnergy Saver Feature LE1711 and LE1911 ModelsModifications C Agency Regulatory NoticesFederal Communications Commission Notice CablesEuropean Union Regulatory Notice Canadian NoticeAvis Canadien German Ergonomics Notice Japanese Notice Korean Notice Power Cord Set RequirementsJapanese Power Cord Requirements Materials Disposal Product Environmental NoticesENERGY STAR Qualification Restriction of Hazardous Substances RoHS HP Recycling ProgramChemical Substances 11363-2006 11363-2006 Turkey EEE RegulationIn Conformity with the EEE Regulation EEE Yönetmeliğine Uygundur D LCD Monitor Quality and Pixel Policy