Installation

The installation must be carried out by a suitably qualified person, in accordance with the current version of the following.

o UK Regulations and Safety Standards or their European

Norm Replacements.

o Building Regulations (issued by the Department of the Environment).

o Building Standards (issued by the Scottish Development Department).

oIEE Wiring Regulations.

oElectricity At Work Regulations.

Before connecting the appliance, make sure that the supply voltage marked on the Rating Plate corresponds with your mains supply voltage.

WARNING: THIS APPLIANCE MUST BE EARTHED.

oThis appliance should be wired into a 13A double pole switched fused spur outlet, having 3 mm contact separation and placed in an easily accessible position adjacent to the appliance. The spur outlet must still be accessible even when your oven is located in its housing.

oTo connect the oven power cord, loosen and remove the cover on the terminal block, in order to gain access to the contacts inside. Make the connection, securing the cord in place with the cable clamp provided and then immediately close the terminal block cover again.

o If you have to change the oven power cord, the earthing (yellow/green) conductor must always be 10 mm longer than the line conductors.

oCare must be taken to ensure that the temperature of the mains supply cable does not exceed 50°C.

oIf the mains supply cable is damaged, then it must be replaced by an appropriate replacement which can be obtained from the Baumatic Spares Department.