Baumatic BDWI640 manual General troubleshooting, Problem Possible What to do Causes

General troubleshooting

PROBLEM	POSSIBLE	WHAT TO DO
	CAUSES
Dishwasher	Fuse blown or the circuit	Replace the fuse or reset the
doesn’t start.	breaker acted.	circuit breaker. Remove any
		other appliances sharing the
		same circuit with the
		dishwasher.
	Power supply is not	Make sure the dishwasher is
	turned on.	turned on and the door is closed
		securely.
		Make sure the power cord is
		properly plugged into the wall
		socket.
	Water pressure is low.	Check that the water supply is
		connected properly and the
		water is turned on.
	Door of the dishwasher is	Make sure to close the door
	not properly closed.	properly until it latches.
Water does	Kink in the drain hose.	Check the drain hose.
not drain from
dishwasher.	Filter clogged.	Check the coarse filter.
	Kitchen sink is clogged.	Check the kitchen sink to make
		sure it is draining well. If the
		problem is the kitchen sink not
		draining, you may need a
		plumber rather than an engineer
		for the dishwasher.
Suds in the	Improper detergent was	Use only specific dishwasher
dishwasher.	used.	detergent to avoid suds. If this
		occurs, open the dishwasher
		door and let the suds evaporate.
		Add 1 gallon of cold water to the
		interior and close the door.
		Select the RAPID program with
		no dishes loaded and allow the
		dishwasher to drain the water.
		Repeat if necessary.
	Spilled rinse-aid.	Always wipe up rinse-aid spills
		immediately.
Stained	A detergent with	Make sure that the detergent
interior.	colourant was used.	used is one without colourant.
White film on	Hard water minerals.	To clean the interior, use a
interior		damp sponge with an
surface.		appropriate dishwasher descaler
		and wear rubber gloves.
		Never use any other cleaner
		than those specifically for

32