2.7 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Placing jumper caps over the headers and connectors will cause permanent damage of the motherboard!
Serial ATA2 Connectors
(SATAII_1: see p.10, No. 14)
(SATAII_2: see p.10, No. 6)
SATAII 1 | SATAII 2 |
These two Serial ATA2 (SATA2) connectors support SATA data cables for internal storage devices. The current SATA2 interface allows up to 3.0 Gb/s data transfer rate.
Serial ATA (SATA) | Either end of the SATA data |
Data Cable | cable can be connected to the |
(Optional) | SATA / SATA2 hard disk or the |
| SATA2 connector on this |
| motherboard. |
|
|
USB 2.0 Headers | Besides the default USB 2.0 |
ports on the I/O panel, there | |
(see p.10 No. 13) | are two USB 2.0 headers on |
| this motherboard. Each |
| USB 2.0 header can support |
| two USB 2.0 ports. |
| |
(see p.10 No. 7) |
|
Consumer Infrared Module Header | This header can be used to |
connect the remote controller | |
(see p.10 No. 10) | receiver. |
|
|
Infrared Module Header | This header supports an |
optional wireless transmitting | |
(see p.10 No. 8) | and receiving infrared module. |
18