Panasonic SC-BTT750 warranty Network Easy Setting, When you experience, Problems with settings

Network Easy Setting

1 Select “Wired” or “Wireless” and press [OK].

Network Easy Setting (Connection Check)

Select a connection mode.

Current setting : Wired

LAN cable connection:

Connect a LAN cable to the unit and select "Wired."

Wireless LAN connection:

Connect the Wireless LAN Adaptor (DY-WL10) to the USB port and select "Wireless."

Wired

Wireless

OK

RETURN

If “Wireless LAN Adaptor is not connected.” is displayed, check that the Wireless LAN Adaptor is fully inserted. Alternatively, disconnect and reconnect it. If there is still no change in the display, consult your dealer.

2 Follow the on-screen instructions and make the settings with [3, 4, 2, 1] and press [OK].

For wireless LAN connection:

If you are using a Wireless router (Access point) that supports WPS, you can easily perform the settings by selecting “WPS (PUSH button method)”.

Otherwise, perform the settings by selecting “Search for access point” or “Manual setting” in “Other methods”.

Access Point Connection Setting

Select a connection method to use with an access point of Wireless LAN.

Please refer to the operating instructions of the access point about connection methods.

WPS (PUSH button method)

	Other methods
OK	Search for access point
	WPS (PIN code method)
RETURN
	Manual setting

≥WPS (Wi-Fi Protected Setup) is a function that facilitates settings relating to the connection and security of wireless LAN devices. To see whether your Wireless router (Access point) supports WPS, check the Wireless router operating instructions.

	When you experience	started
	problems with settings
Access Point Connection Setting
		Getting
	Failed to connect to the access point.
Access Point Connection Setting

A conflict with another device occurred.

Do you want to configure Access Point Connection

Setting again ?

YesNo

OK

Display	Check the following
A conflict with another	≥ Please wait a few moments,
device occurred.	and then try again.

≥Setting of the Wireless router (Access point) for

A time out error occurred. MAC Address etc.

≥[BTT750] The signal may be weak. Using the supplied USB extension cable, adjust the position of the Wireless LAN Adaptor. Do not use any other USB extension cables except the supplied one.

≥[BTT350] The signal may be weak. Using the USB extension cable supplied

An authentication error or a	with the Wireless LAN
time out error occurred.	Adaptor, adjust the position
	of the Wireless LAN
	Adaptor.

			≥ The SSID (> 20) and the
			encryption key of the
			Wireless router (Access
			point).
			≥ Please wait a few moments,
			and then try again.
			≥ Connection of Wireless LAN
A device error occurred.			Adaptor
			If there is no improvement in
			symptom, contact our
			Customer Service Center.
Network Easy Setting (Connection Check)
Network Easy Setting (Connection Check)
	Complete.
	1. LAN cable connection	: Fail
	2. IP address setting	: Fail
	3. Connection to gateway	: Fail
	LAN cable is not connected.
	Please check the connection.
	Select “Yes” and press [OK] to check network
	connection again. Select “No” and press [OK]
	to finish Network Easy Setting.
	Yes	No
	OK
		Display		Check the
				following
1. LAN cable connection or			:Fail	≥ Connection of
Connection to access point				the LAN
2. IP address setting			:Fail	cables (> 16)	VQT2W18
3. Connection to gateway			:Fail		19