1.2Getting started
1.2.1Set-up
Inserting or removing the SIM card and microSD card (1)
You must insert your SIM card to make phone calls. Please power off your phone before inserting or removing the SIM card and microSD card.
Inserting or removing SIM cards (2)
There are two SIM card slots on the phone. You can insert one or two SIM cards into slots. Please power off your phone before inserting or removing SIM cards.
Your phone only support
To install, take off
To remove the card, open
Steps for removing and installing microSD card are the same with steps for
(1)6012X only.
(2)6012D only.
Charging the battery
Connect the battery charger to your phone and mains socket respectively.
•When using your telephone for the first time, charge the battery fully (approximately 5 hours).
You are advised to fully charge the battery ( ). Charging status is indicated by the percentage on screen while the phone is powered off. The percentage increases as the phone is charged.
The charging status bar will not float if your battery is extendly consumed. To reduce power consumption and energy waste, when battery is fully charged, disconnect your charger from the plug; switch off
1.2.2Power on your phone
Hold down the Power key until the phone powers on, unlock your phone (Slide, PIN, Password, Pattern, Face unlock or Voice unlock) if necessary and confirm. The Home screen will display.
If you do not know your PIN code or if you have forgotten it, contact your network operator. Do not leave your PIN code with your phone. Store this information in a safe place when not in use.
17 | 18 |