Alcatel manual OT-606A Bluetooth QD ID B016876, Radio Waves

Page 6

RADIO WAVES:

THIS CELLPHONE MEETS THE GOVERNMENT’S REQUIREMENTS FOR EXPOSURE TO RADIO WAVES.

Your cellphone is a radio transmitter and receiver. It is designed and manufactured not to exceed the emission limits for exposure to radio-frequency (RF) energy. These limits are part of comprehensive guidelines and establish permitted levels of RF energy for the general population. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. These guidelines include a substantial safety margin designed to ensure the safety of all persons, regardless of age and health.

The exposure standard for cellphones employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by public authorities such as the Federal Communications Commission of the US Government (FCC), or by Industry Canada, is 1.6 W/kg averaged over 1 gram of body tissue. Tests for SAR are conducted using standard operating positions with the cellphone transmitting at its highest certified power level in all tested frequency bands.

Although the SAR is determined at the highest certified power level, the actual SAR level of the cellphone while operating can be well below the maximum value. This is because the cellphone is designed to operate at multiple power levels so as to use only the power required to reach the network. In general, the closer you are to a wireless base station antenna, the lower the power output of the cellphone Before a cellphone model is available for sale to the public, compliance with national regulations and standards must be shown.

The highest SAR value for this model cellphone when tested is 0.854 W/Kg for use at the ear and 1.24 W/Kg for use close to the body.

While there may be differences between the SAR levels of various cellphones and at various positions, they all meet the government requirement for RF exposure. For body-worn operation, the cellphone meets FCC RF exposure guidelines provided that it is used with a non-metallic accessory with the handset at least 1.5 cm from the body. Use of other accessories may not ensure compliance with FCC RF exposure guidelines.

The World Health Organization (WHO) considers that present scientific information does not indicate the need for any special precautions for use of cellphones. If individuals are concerned, they might choose to limit their own or their children’s RF exposure by limiting the length of calls, or using “hands-free” devices to keep cellphones away from the head and body. (fact sheet n°193). Additional WHO information about electromagnetic fields and public health are available on the following website: http://www.who.int/peh-emf.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/ TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

For the receiver devices associated with the operation of a licensed radio service (e.g. FM broadcast), they bear the following statement:

This device complies with Part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference.

For other devices, they bear the following statement:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)this device may not cause harmful interference

(2)this device must accept any interference received, including interference that may cause undesired operation.

Your cellphone is equipped with a built-in antenna. For optimal operation, you should avoid touching it or degrading it.

As cellphone devices offer a range of functions, they can be used in positions other than against your ear. In such circumstances the device will be compliant with the guidelines when used with headset or usb data cable. If you are using another accessory ensure that whatever phone is used is free of any metal and that it positions the cellphone at least 2cm away from the body.

LICENCES

Obigo®

is a registered trademark of Obigo AB.

 

 

 

microSD Logo is a trademark.

 

 

 

The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc. and

 

 

 

any use of such marks by TCT Mobile Limited and its affiliates is under license.

 

 

 

Other trademarks and trade names are those of their respective owners.

 

 

 

OT-606A Bluetooth QD ID B016876

 

 

 

eZiText™ and Zi™ are trademarks of Zi Corporation and/or its Affiliates.

 

 

 

 

 

 

 

 

 

 

 

 

Java™ and all Java™ based trademarks and logos are trademarks or registered

 

 

 

trademarks of Sun Microsystems, Inc. in the U.S. and other countries.

 

 

 

is a registered trademark of Opera Mini.

Hearing Aid Compatibility

Your cellphone is rated: "For Hearing Aid", to assist hearing device users in finding phones that may be compatible with their hearing devices.

This device is HAC M3 compatible.

For more information please refer to "Hearing Aid Compatibility with Mobile Phones" leaflet or visit our website http://www.alcatel-mobilephones.com/

9

10

Image 6
Contents Page Table of contents Introduction10.3 10.110.2 10.4Safety and use Privacy OT-606A Bluetooth QD ID B016876 Radio WavesProtection against theft Cellphone or specific operator servicesGeneral information DisclaimerYour cellphone Status bar icons Battery charge levelBluetooth status Activated Headset connected Keypad lockedWidget bar Personalize mainscreenSimple menu Two widgets cannot be removed Calls, MessagesGetting started Installing or removing the batteryCharging the battery Set-upMaking a call Power on your cellphonePower off your cellphone Calling your voicemailReceiving a call During a callConference calls Menu arrange Line switchingRestore factory settings Change the orderMessages AccessConversational mode and conventional mode Create messageAvailable options Inbox Email account set-upCreate Email OutboxInstant messaging1 Open a Palringo account onlineSign in/Sign out Directory Adding a contact Call log Call settingsCalls My numbersMedia applications MusicVideo Play modeImage RadioInternet Opera11.2 Wap Stopwatch EntertainmentWeather JavaDisclaimer CameraCamera Store them in your File manager\My creationsFraming mode Settings in framing modeAccess Video Recording modeProfiles File manager Managing audios, images, videos and creations Formats and compatibilityMemory status Bluetooth Calculator OthersCalendar ClockSettings Cellphone settingsConverter Security Connectivity Making the most of your CellphoneNetwork PC suitePredictive eZi mode Latin input mode/characterNormal Alcatel Mobile Phones Limited Warranty Symbol table22Accessories 23Troubleshooting Carry out the following checksSound quality of the calls is not optimal Used under license by TCT Mobile Limited