ASRock N68C-GS FX manual Multiplier/Voltage Change, CPU Frequency Multiplier, Processor Voltage

Multiplier/Voltage Change

This item is set to [Auto] by default. If it is set to [Manual], you may adjust the value of Processor Frequency and Processor Voltage. However, it is recommended to keep the default value for system stability.

BIOS SETUP UTILITY

Main OC Tweaker Advanced H/W Monitor Boot Security Exit

CPU Configuration

Overclock Mode	[Auto]
CPU Frequency (MHz)	[200]
PCIE Frequency (MHz)	[100]
Boot Failure Guard	[Enabled]
	[3]
Boot Failure Guard Count
CPU/LDT Spread Spectrum	[Enabled]
PCIE Spread Spectrum	[Enabled]
SATA Spread Spectrum	[Enabled]
ASRock UCC	[Disabled]
AMD Turbo Core Technology	[Auto]
AMD IO C-State Support	[Enabled]
CPU Active Core Control	[Disabled]
Processor Maximum Frequency	x16.5 3300 MHZ
North Bridge Maximum Frequency	x10.0 2000 MHZ
Processor Maximum Voltage	1.43750 V
Multiplier/Voltage Change	[Manual]

Overclocking may cause damage to your CPU and motherboard.

It should be done at your own risk and expense.

	Select Screen
	Select Item
Enter	Go to Sub Screen
F1	General Help
F9	Load Defaults
F10	Save and Exit
ESC	Exit

v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.

CPU Frequency Multiplier

For safety and system stability, it is not recommended to adjust the value of this item.

Processor Voltage

It allows you to adjust the value of processor voltage. However, for safety and system stability, it is not recommended to adjust the value of this item.

NB Frequency Multiplier

For safety and system stability, it is not recommended to adjust the value of this item.

HT Bus Speed

This feature allows you selecting Hyper-Transport bus speed. Configura- tion options: [Auto], [x1 200 MHz] to [x5 1000 MHz].

HT Bus Width

This feature allows you selecting Hyper-Transport bus width. Configura- tion options: [Auto], [8 Bit] and [16 Bit].

Memory Configuration

This item can be set by the code using [Auto]. You can set one of the standard values as listed for DDR2 memory modules: [200MHz DDR2_400], [266MHz DDR2_533], [333MHz DDR2_667] and [400MHz DDR2_800]. If you adopt Phenom CPU, there is one more option: [533MHz DDR2_1066]. You can set one of the standard values as listed for DDR3 memory modules: [400MHz DDR3_800], [533MHz DDR3_1066], [667MHz DDR3_1333] and [800MHz DDR3_1600].

DRAM Voltage

Use this to select DRAM voltage. The default value is [Auto].

37