Jabra C220 manual Regulatory Information, Regulations Statements, Class B Regulations

Page 29

Regulatory Information

4

Regulatory Information

NOTE: Marking labels located on the exterior of your device indicate the regulations that your model complies with. Please check the marking labels on your device and refer to the corresponding statements in this chapter. Some notices apply to specific models only.

4.1 Regulations Statements

Class B Regulations

USA

Federal Communications Commission Radio Frequency Interference

Statement

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

zReorient or relocate the receiving antenna.

23

Image 29

Contents Page Trademarks 2 Settings Table of Contents3 Troubleshooting and Maintenance 1 Getting Started4 Regulatory Information Warnings and Notices Do not mount in front of airbag panels Do not place on the dashboard unsecured1.1 Understanding Hardware Components Getting StartedFront Components ComponentRight-SideComponents Back ComponentsComponent DescriptionBottom Components Top ComponentsConnects to stereo headphones Connector1.2 Performing the Initial Start Up Page Connecting the Car Charger 1.3 Using Your Device in a VehicleUsing the Device Holder Navigating on the Screen 1.4 Operating BasicsTurning On and Off zTap Home ScreenzDrag zTap and holdzMake sure that no foreign objects enter the slot 1.5 Inserting a SD/MMC CardPage 2.1 Starting and Exiting Settings Settings1.Tap the Settings button on the Home screen 2.2 Backlight2.Tap the Backlight button 4. Tap to save the changes1.Tap the Settings button on the Home screen 2.3 Volume2.Tap the Volume button 4. Tap save the changes1.Tap the Settings button on the Home screen 2.4 Screen2.Tap the Screen button 3. Tap to start the calibration2.5 Power 1.Tap the Settings button on the Home screen 2.6 Date&Time4. Tap to save the changes 2.Tap the Date&Time button2.7 Change Language 4.Tap to save the changes 3.1 Restart and Shut Down Troubleshooting and MaintenanceRestarting Your Device Shutting Down Your DevicePower Problems 3.2 TroubleshootingScreen Problems Connection Problems3.3Maintaining Your Device GPS ProblemsDo not use paper towels to clean the screen 4.1 Regulations Statements Regulatory InformationClass B Regulations StatementPlease note European NoticeCanada Canadian Department Of Communications EN60950 / IEC 60950 Product Safety 4.2 Safety PrecautionsAbout Charging About the ChargerAbout the Battery