BIOS Setup
▶ Hardware Monitor
Press <Enter> to enter the
▶ CPU Smart FanTarget
The Smart Fan function controls the CPU fan speed automatically depending on the current temperature to keep it with in a specific range. You can enable a fan target value here. If the current CPU fan temperature reaches to the target value, the smart fan function will be activated.
▶ SYS Fan 1/ 2 Control
These items allow users to select how percentage of speed for the SYSFAN1/ 2.
▶ CPU/ System Temperature, CPU FAN/ SYS FAN 1/ 2 Speed
These items show the current status of all of the monitored hardware devices/com- ponents such as CPU temperature/ system temperature and all fans’ speeds.
▶ Power Management Setup
Press <Enter> to enter the
▶ EuP 2013
This item is designed for Energy Using Products Lot 6 2013 (EuP) aka Energy Re- lated Products (ErP). To reduce Power Consumption when system off or standby mode.
Note: When “Enabled” EuP 2013 setting, system don’t support RTC wake up event function.
▶ Restore after AC Power Loss
This item specifies whether your system will reboot after a power failure or interrupt occurs. Settings are:
[Power Off] | Always leaves the computer in the power off state. |
[Power On] | Always leaves the computer in the power on state. |
[Last State] | Restore the system to the status before power failure or interrupt |
| occurred. |
▶ Wake Up Event Setup
Press <Enter> to enter the