BIOS Setup
▶Serial
(COM) Port0
This item allows you to enable/ disable the serial port.
▶Serial
(COM) Port0 Settings
Select an address and corresponding interrupt for the serial port.
▶Parallel(LPT) Port Configuration Press <Enter> to enter the
▶Parallel(LPT) Port
This item allows you to enable/ disable the parallel port. ▶Parallel(LPT) Port Settings
Select an address and corresponding interrupt for the parallel port.
▶Device Mode
Select a device mode for the parallel port.
▶Hardware Monitor
Press <Enter> to enter the
▶CPU Smart Fan
Target
Controls CPU fan speed automatically depending on the current temperature and to keep it with a specific range. If the current CPU temperature reaches the target value, the smart fan function will be activated.
▶SYS Fan1 Control
This item allows users to select how percentage of speed for the SYSFAN1.
▶CPU/ System Temperature, CPU FAN/ SYS FAN 1/ 2 Speed
These items show the current status of all of the monitored hardware devices/ com- ponents such as CPU temperature/ system temperature and the few fans’ speeds.
▶Intel(R) Smart Connect Configuration Press <Enter> to enter the
▶Intel(R) Smart Connect Technology
This item allows you to enable/ disable Intel® Smart Connect Technology. When you enable it, the system will be woked periodically from Sleep/Standy mode for a brief period of time to update programs.
▶Power Management Setup
Press <Enter> to enter the
Energy Using Products Lot 6 2013 (EUP) reduces power consumption when system is off or in standby mode.
Note: When enabled, the system will not support RTC wake up event functions.
▶Restore after AC Power Loss
This item specifies whether your system will reboot after a power failure or interrupt occurs. Settings are:
[Power Off] | Always leaves the computer in the power off state. |
[Power On] | Always leaves the computer in the power on state. |
[Last State] | Restore the system to the status before power failure or interrupt |
| occurred. |