7Troubleshooting
Drying process takes too much time.
•Pores of the lint filter are clogged. >>> Wash the lint filter with warm water.
•Filter drawer is clogged. >>> Clean the sponge and the filter cloth in the filter drawer.
•Ventilation grids on the front side of the machine are blocked. >>> Remove the objects (if any) that block ventilation in front of the ventilation grids.
•Ventilation is not sufficient since the room where the machine is installed is very small. >>> Open the door and window of the room to avoid the room temperature increase too much.
•Lime deposit has built up on the dampness sensor. >>> Clean the dampness sensor.
•Excessive laundry is loaded. >>> Do not load the dryer in excess.
•Laundry is not spun sufficiently. >>> Spin your laundry at a higher speed in your washing machine.
Laundry comes out wet at the end of drying.
C After drying, the hot clothes feel damper than their actual dampness level.
•It is likely that the selected programme did not suit the laundry type.>>>Checking the care labels on clothes, select appropriate programme for the laundry type or use timer programmes in addition.
•Pores of the lint filter are clogged. >>> Wash the lint filter with warm water.
•Filter drawer is clogged. >>> Clean the sponge and the filter cloth in the filter drawer.
•Excessive laundry is loaded. >>> Do not load the dryer in excess.
•Laundry is not spun sufficiently. >>> Spin your laundry at a higher speed in your washing machine.
Dryer does not switch on or the programme does not start. Dryer does not start when it is set.
•It is not plugged in. >>> Make sure that the machine is plugged in.
•The loading door is ajar. >>> Make sure that the loading door is closed securely.
•Programme is not selected or the Start / Pause / Cancel button is not pressed. >>> Make sure that the programme is selected and the machine is not in Pause mode.
•Childproof Lock is activated. >>> Deactivate the Childproof Lock.
Programme is interrupted without any cause.
•Loading door is ajar. >>> Make sure that the loading door is closed securely.
•There was a power failure. >>> Press Start / Pause / Cancel button to start the programme.
•Water tank is full. >>> Drain the water tank.
Laundry has shrunk, become felted or deteriorated.
•A programme suitable for the laundry type is not used. >>> Check the garment tag and select a programme suitable for the fabric type.
Drum lighting does not turn on. (On models with lamp)
•Dryer is not switched on with the On / Off button. >>> Make sure that the dryer is switched on.
•Lamp is defective. >>> Call Authorized Service Agent to have the lamp replaced.
End/Anti-creasing symbol is on.
•
Dryer / User Manual | 29 / 32 EN |
|
|