2 Installation
Refer to the nearest Authorised Service Agent for installation of the machine . To make the machine ready for use, review the information in the user manual and make sure that the electricity, tap water supply and water drainage systems are appropriate before calling the Authorized Service Agent. If they are not, call a qualified technician and plumber to have any necessary arrangements carried out.
C Preparation of location, electrical, tap water and waste water installations of the machine are the customer's responsibility.
Ensure that the water inlet and discharge hoses as well as the power cable are not folded, pinched or crushed, during or after installation or cleaning procedures.
B Warning: Installation and electrical connections of the machine must be carried out by an Authorized Service Agent. The Manufacturer shall not be held liable for damages that may arise.
A Warning: Prior to installation, visually check if the machine has any defects on it. If so, do not have it installed. A damaged machine is a safety risk.
2.1 Appropriate installation location
•Place the machine on a rigid floor that has sufficient load carrying capacit. Do not place it on a long pile rug or similar surfaces.
•Total weight of the washing machine and the dryer
•Do not place the machine on the power cable.
•Do not install the machine at places where temperature may fall below 0ºC.
•Place the machine at least 1 cm away from the edges of other furniture.
2.2 Removing packaging reinforcement
Tilt the machine backwards to remove the packaging reinforcement. Remove the packaging reinforcement by pulling the ribbon. Do not perform this operation alone.
2.3 Removing the transportation locks
A warning: Do not remove the transportation locks before taking out the packaging reinforcement.
warning: Remove the transportation safety bolts before operating the washing machine! Otherwise, the machine will be damaged.
1.Loosen all the bolts with a suitable spanner until they rotate freely (C).
2.Remove transportation safety bolts by turning them gently.
3.Attach the plastic covers supplied in the User Manual bag into the holes on the rear panel. (P)
C Keep the transportation safety bolts in a safe place to reuse when the washing machine needs to be moved again in the future.
Never move the machine without the transportation safety bolts properly fixed in place!
2.4 Connecting water supply
C The water supply pressure required to run the machine is between 1 to 10 bars (0.1 – 1 MPa). It is necessary to have 10 – 80 liters of water flowing from the fully open tap in one minute to have your machine run smoothly. Attach a pressure reducing valve if water pressure is higher.
If only the single (cold)
A warning: Models with a single water inlet must not be connected to the hot water tap. In such a case the laundry will get damaged or the machine will switch to protection mode and will not operate.
warning: Do not use old or used water inlet hoses on the new machine . It may cause stains on your laundry.
5 / EN | Washing Machine / User’s Manual |
|
|