MODEL QTXN110HL
CONNECT WIRING
Page 3
INSTALL GRILLE & BULBS
HEAT |
| LIGHT |
|
& |
| & |
|
NIGHT LIGHT | FAN | VENTILATOR | |
|
|
| |
RED to BLACK |
|
| HOUSING |
|
|
| |
(Heat) |
|
| RED to RED |
BLACK to YELLOW |
|
| |
|
| (Fan) | |
(Night Light) |
|
| |
|
|
| |
|
|
| BLACK to BLUE |
|
|
| (Light) |
WHITE to WHITE |
|
| WHITE to WHITE |
WIRING PLATE | GROUND | BLACK to RED | |
FROM VENTILATOR | |||
|
|
| BLACK to BLUE |
WHITE |
|
|
|
to |
|
| LIGHT (red) |
WHITE |
|
| |
|
|
| NIGHT LIGHT (blue) |
CAUTION |
|
| |
|
| FAN | |
RATING SPECIFICATIONS |
|
| |
|
|
| |
8. Plug-in light.
Hold grille assembly up near housing. Connect light plug from grille assembly to receptacle inside of housing.
GRILLE MOUNTING |
SCREWS |
• The | RED | HEAT | |
|
| ||
rocker switch is rated 5 A |
| NuTone | |
@ 125VAC. Use this switch |
| ||
for Lights ONLY. | 120 VAC LINE IN | Control shown | |
(purchase separately) | |||
• Each | BLACK to BLACKS | ||
|
|
switch is rated 15 A @ 120VAC. Use these switches for Heat and Vent.
• The total load on this control must not exceed 20 A @ 120VAC.
5. Connect electrical wiring.
Run 120 VAC house wiring to installation location. Use proper UL approved connectors to secure house wiring to wiring plate. Connect wires as shown in wiring diagram(s).
INSTALL GRILLE & BULBS
6. Finish ceiling.
Install ceiling material. Cut out ceiling material closely around housing.
7.Remove light lens
from grille.
Insert a small flat- bladed screw- driver into the slot at one end of the light lens. Carefully pry the lens out.
9. Attach grille.
Remove the (2) grille mounting screws from the sides of the housing. (See Step 8 illustra- tion.) Use these screws to attach the grille to the housing as shown.
To avoid damage to the grille: DO NOT OVERTIGHTEN SCREWS. Tighten screws only until grille is snug against ceiling material.
10. Install bulbs.
The unit accepts (2) 60- Watt (maxi- mum) incandes- cent bulbs and
(1)
11.Attach light lens.
Hook the tabs on one end of the lens into the slot in the grille. Lift other end of lens up and snap into place.