Maytag HR6120SJRT, HR652SJRT, HR682SJRT, HR666DJRT manual Installation Checklist, Model Rating Plate

Page 15

Instructions for Installation (cont’d)

Installation Checklist

1.Whether or not the element conversion is made, the model rating plate must be marked. Using a hard point ink pen, check the appropriate block within the model rating plate, which is located adjacent to the lower access panel.

2.Is the fuse or circuit breaker size correct as shown in the chart in the “Product Specifications” section?

3.Are the wires from the circuit breaker or fuse service to the water heater’s junction box on the correct wire size (gauge) as shown in the chart in the “Product Specifications” section?

4.Is the new temperature-pressure relief valve properly installed, and piped to an adequate drain? See “Temperature-Pressure Relief Valve” in the “Instructions for Installation” section.

5.Is the water heater completely filled with water? See “Filling the Water Heater” instructions in the “Instructions for Installation” section.

6.Will a water leak damage anything? See “Locating the New Water Heater” in the “Instructions for Installation” section.

7.Are the cold and hot water lines connected to the water heater correctly? See “Water Piping” instructions in the “Instructions for Installation” section.

8.Is there adequate clearance for maintenance around the water heater?

9.Do you need to call your electric company to check your wiring?

HOT

COLD

 

HOT COLD

CONDUIT

TEMPERATURE-

PRESSURE

RELIEF VALVE

DISCHARGE PIPE (Do not cap or

plug)

6” AIR GAP

FLOOR DRAIN

MODEL RATING PLATE

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Series Six Safety Instructions Safety Instructions cont’d Table of Contents Product Specifications Customer In formationHR630SJRT HR630DJRT HR630SJLS HR630DJLS HR640SJRT HR640DJRT HR640SJRS HR640DJRS HR640SJLS HR640DJLS HR652SJRT HR652DJRT HR650SJRS HR650DJRS HR650SJLSHR650DJLS HR666SJRT HR666DJRT HR682SJRT HR682DJRT HR6120SJRT HR6120DJRT Product SpecificationsTools Accessories and Tools NeededAccessories Additional Tools Needed When Sweat SolderingRemoving the Old Water Heater Installation InstructionsInstructions for Installation cont’d Typical InstallationLocating The New Water Heater Valve and Pipe Insulation Water PipingTemperature-Pressure Relief Valve Wiring Diagrams Standard Wiring for Single Element 240 VoltFilling the Water Heater Wiring Model Rating Plate Installation ChecklistThermostats Service and MaintenanceTemperature Regulation Temperature SettingsAnode Rod Inspection Service and Maintenance cont’dThermostat Adjustments Temperature-Pressure Relief Valve OperationDraining Thermostat Removal/ReplacementThermostat Removal cont’d Element Cleaning ReplacementLower Thermostat Element Cleaning Replacement cont’d Drain Valve Washer ReplacementService Troubleshooting Start Up ConditionsOperational Conditions Not Enough or no HOT Water Troubleshooting cont’dLeakage Checkpoints Page Repair Parts List Repair Parts List cont’d This is a Repair Parts LIST, not a Packing ListSee Repair Parts List cont’d See Note on Repair Parts List cont’d Model Number Serial Number Part Description Repair Parts List cont’d Repair Parts List cont’d Maytag State Page Limited Tank Warranty Against Leaks WarrantyFull ONE Year Warranty Limited Parts Warranty
Top Page Image Contents