Maytag HRE3950S, HRE3966T, HRE3950T manual Filling the Water Heater, Converting the Lower Element

Page 13

Instructions for Installation (cont’d)

Filling the Water Heater

To fill the water heater with water:

1.Close the water heater drain valve by turning the handle to the right (clockwise). The drain valve is on the lower front of the water heater.

2.Open the cold water supply valve to the water heater.

NOTE: The cold water supply valve must be left open when the water heater is in use.

3.To insure complete filling of the tank, allow air to exit by opening the nearest hot water faucet. Allow water to run until a constant flow is obtained. This will let air out of the water heater and the piping.

CAUTION

Never use this water heater unless it is completely full of water. To prevent damage to the tank and heating element, the tank must be filled with water. Water must flow from the hot water faucet before turning “ON” power.

4. Check all new water piping for leaks. Repair as needed.

Converting the Lower

Element

These instructions only cover the conversion of the convert- ible element, read this entire manual before attempting to install or operate the water heater. The water heater is factory set to operate at 3800 watts. The lower element can be con- verted to operate at 5500 watts. Refer to “The Convertible Lower Element” section.

The Upper Element is a conventional 3800 watt element which only operates at its rated wattage on 240 volts. (See rat- ing plate on water heater).

The Lower Element of the water heater can be converted from operation at 3800 watts to 5500 watts on a 240 volt sys- tem.

If after reading these instructions and this manual, if you do not understand any portion, call Maytag Customer Service at 1-800-788-8899 for an authorized servicer.

WARNING

Before making the conversion to 5500 watts, check the (1) power supply...must be 240 volts, (2) wiring...10 gauge AWG @ Type TW, 60°C or equiva- lent, and (3) Circuit breakers or fusing...capable of 30 amp loading. Also, the installation must con- form with this Manual, local codes and electric utili- ty rules. FAILURE TO COMPLY CAN RESULT IN DEATH, SERIOUS BODILY INJURY OR PROPERTY DAMAGE.

NOTE: Whether or not the element conversion is made the model rating plate must be marked. Using a hard point ink pen, check the appropriate block within the model rating plate, which is located adjacent to the lower access panel.

Necessary element conversion parts are located in a small bag contained within the large plastic manual envelope attached to the side of the water heater.

CONVERSION PARTS

5500 W

SCREW

BUSS BAR

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Electric Water Heater USER’S Guide DEATH, Serious Bodily INJURY, or Property Damage Safety InstructionsSafety Instructions cont’d Table of Contents Customer Information Minimum Wire Size Gauge Product SpecificationsAccessories Accessories and Tools NeededAdditional Tools Needed When Sweat Soldering ToolsRemoving the Old Water Heater Instructions for InstallationTypical Installation Instructions for Installation cont’dLocating The New Water Heater Check ALL Connections for LeaksOUS Bodily INJURY, or Property Damage Convertible Lower ElementValve and Pipe Insulation Water Piping″ AIR GAP Floor Drain Temperature-Pressure Relief ValveConverting the Lower Element Filling the Water HeaterConverting the Lower Element cont’d OUS Bodily INJURY, or Property Damage Standard Wiring for Wiring DiagramsLength in any ground return path does not exceed 6 feet WiringModel Rating Plate Installation ChecklistTemperature Regulation Service and MaintenanceTemperature Settings ThermostatsThermostat Adjustments Service and Maintenance cont’dTemperature-Pressure Relief Valve Operation Anode Rod InspectionDraining Thermostat Removal/ReplacementThermostat Removal cont’d Element Cleaning ReplacementService and Maintenance cont’d Drain Valve Washer Replacement Element Cleaning Replacement cont’dService Start Up Conditions TroubleshootingOperational Conditions Not Enough or no HOT Water Troubleshooting cont’dLY INJURY, or Property Damage Leakage CheckpointsMaytag Electric Water Heaters Model Numbers Repair Parts ListGallon Repair Parts List cont’dKEY Part Description Part NumbersHRE2940L Element Gasket 66001053 Primary Anode 66001723 HRE2950S HRE3950S HRE2950T HRE3950T HRE2966T HRE3966T ETC2X Page Full ONE Year Warranty Warranty

HRE3950S, HRE2940S, HRE3930T, HRE2966T, HRE3940L specifications

The Maytag ranges HRE2950S, HRE2940S, HRE2940T, HRE3940S, and HRE3930T stand out in the crowded appliance market, known for their robust design and innovative features. Each model is designed with the home chef in mind, ensuring that meal preparation is both efficient and enjoyable.

One of the primary features across these models is the durable cast-iron grates that provide a professional cooking experience. They offer excellent heat retention and stability for pots and pans, allowing for optimal heat distribution when cooking. The grates are also easy to clean, making maintenance a breeze.

Another key technology integrated into these ranges is the precise temperature control, which comes from the advanced direct flame technology. This ensures that cooking temperatures can be accurately maintained, enabling recipes to be executed flawlessly. This is particularly beneficial for baking and searing, where precision is crucial.

The HRE2950S and HRE2940S models come equipped with a powerful 15,000 BTU burner, perfect for boiling and frying, while the HRE2940T model features a high-efficiency burner designed to save energy without sacrificing performance. These powerful burners allow for a range of cooking methods, from fast boiling to slow simmering.

Cooking companions in these ranges include a self-cleaning oven feature, which takes the hassle out of cleaning after a long day of cooking. The self-cleaning cycle uses high temperatures to burn off debris and food residue, resulting in a clean oven without scrubbing or harsh chemicals.

The HRE3940S and HRE3930T models are especially notable for their spacious oven capacity, which allows multiple dishes to be cooked simultaneously. This feature is ideal for entertaining or large family meals, ensuring ample room for various culinary creations.

In addition to functionality, aesthetic appeal is crucial. These Maytag ranges boast a sleek, modern design with a stainless-steel finish that adds a touch of elegance to any kitchen. The ergonomic knobs and handles complement the professional appearance, making these ranges as attractive as they are efficient.

With a commitment to durability, performance, and ease of use, the Maytag HRE2950S, HRE2940S, HRE2940T, HRE3940S, and HRE3930T are perfect for aspiring chefs and seasoned cooks alike. These ranges combine innovative features with practical functionality, making them a valuable addition to any household kitchen.
Top Page Image Contents